Before The First Usage; Operation; Filling With Water - SilverCrest SDRB 1000 A1 Mode D'emploi

Attention!
• Should the care instructions in the clothing item
forbid ironing (Symbol
steam brush on it. Should you do so, the clothing
item could be permanently damaged.
• The water tank is to be filled exclusively with mains
water (or a mix of distilled and mains water).
You will otherwise damage the appliance.
• You may not clean the appliance with solvents,
alcohol or abrasive cleaning agents. These could
cause damage to it.

Before the First Usage

• Remove the steam brush from the packaging.
• Remove all possible adhesive tags and protective
foils from the steam iron.
• Remove the protective cap from the brush attach-
ment w.
Attention!
Plastic bags can be dangerous. To avoid fatalities
through suffocation, keep plastic bags out of the
reach of children.
• Fill the water tank 1 with water (see chapter

"Filling with water").

• Insert the power plug 7 into a correctly instal-
led and earthed mains power socket.
• Hold the steam brush horizontally.
• Place the temperature regulator 3 at the posi-
tion "MAX".
• Heat the steam brush up at the highest setting
for a few minutes. By doing this you will clear
production residues from the sole 0 of the
appliance.
• Activate the steam shot button 8 a few times, so
that steam exits from the soleplate 0.
), you may not use the
• Then iron a redundant piece of material, this will
remove any impurites that may possibly be on
the sole of the iron 0.
Note:
On the first heating up of the appliance a small volume
of smoke and smell may be generated, caused by
production residues. This is completely normal and
is not dangerous. Provide for sufficient ventilation,
for example, open a window.

Operation

Note:
• Should the care instructions in the clothing item
forbid ironing (Symbol
the steam brush on it. If you do so, the clothing
item could be permanently damaged.
• Do NOT use the appliance on leather, velvet, im-
pregnated furniture or steam sensitive materials.
If you do, the material/furniture could become
damaged.
Filling with water
Attention!
Fill the watertank 1 exclusively with tap water or distil-
led water mixed with tap water. Never fill watertank 1
with chemical substances, cleaning agents (with the ex-
ception of decalcification agents) or other liquids.
Do not use chemically distilled water. This would
irreparably damage the appliance.
Should the mains water at your locality be rated as
hard, it is recommended that you mix mains water
with some distilled water. Otherwise, the jets for the
steam blast function could calcify (become blocked)
prematurely.
- 40 -
), you may not use