Nikon Optos California P200DTx rg Manuel D'utilisation page 61

IEC60601 compliance test
Immunity test
level
<5% U
(>95%dip in U
for 0.5 cycle
Voltage dips, short
40% U
interruptions and
(60% dip in U
voltage variations
for 5 cycles
on power supply
lines
IEC61000-4-11
70% U
(30% dip in U
for 25 cycles
<5% U
(>95% dip in U
for 5 seconds
Power frequency
(50/60Hz)
3 A/m
Magnetic field
IEC61000-4-8
Note: U T is the a.c. mains voltage prior to the application of the test level.
Conductive RF 3Vrms
IEC61000-4-6 150kHz to 80MHz
Radiated RF 3V/m
IEC61000-4-3 80MHz to 2.5GHz
Note 1 : At 80MHz and 800MHz the higher frequency range applies.
Note 2 : These guidelines may
absorption and reflection from structures, objects and people.
Part Number: G108025/4GCA
Copyright 2017, Optos plc. All rights reserved.
Electromagnetic environment-guidance
T
)
T
Mains power quality should be that of a typical
commercial or hospital environment. If the user of the
T
) device requires continued operation during mains
T
interruptions, it is recommended that the device be
powered from an uninterruptible power supply.
T
)
T
If the user of the device requires continued operation
T
) during mains interruptions, it is recommended that the
T
device be powered from an uninterruptible power supply.
Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical
commercial or hospital environment.
Portable and mobile RF communications equipment
should be used no closer to any part of the device,
including cables, than the recommended separation
distance calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance
d=1.2√P
d=1.2√P 80MHz to 800MHz
d=2.3√P 800MHz to 2.5GHz
Where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation
distance in metres (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic survey,
less than the compliance level in each frequency range.
Interference may occur in the vicinity of equipment
marked with:
apply in all situations. Electromagnetic propagation is affected by
NOT
Chapter 4 - Technical Specification
a
should be
Page 61 of 69
English
b