How To; Get Started; Switch On Each Day; Switch On The Image Server - Nikon Optos California P200DTx rg Manuel D'utilisation

3

How to...

Before using the system and capturing images, you should be familiar with all the features and capabilities of
the system.

3.1 Get started

CAUTION
Your device should be left in standby mode at the end of each working day.
Note
The device automatically logs out and the touch screen goes dark when the device is
touch screen activates the touch screen and lets you log in.

3.1.1 Switch on each day

The image server and scan head must be switched

3.1.1.1 Switch on the image server

The review, admin and storage services run on the image server. You do
as the server only needs to be switched on.
Your image server may also be used as a browser-based review client.
1. Check that the power supply is switched on.
2. Switch on the image server.
Note
If it seems the image server is not working, check the monitor is switched on then confirm the image server is
switched on.

3.1.1.2 Switch on the scan head

CAUTION
The scan head should be left in standby mode at the end of each working day and so will need to be started
each day.
Part Number: G108025/4GCA
Copyright 2017, Optos plc. All rights reserved.
Read the warnings and cautions before using your device.
If applicable, also read the country-specific warnings and cautions, see Country-specific
warnings and cautions on page 20.
Only use the fabric cover when the scan head is powered
Remove the fabric cover before operating the scan head.
The scan head will move when the alignment system is being centered. This will happen
automatically when the device is switched
centered between patient sessions. You should ensure that there is space around the
scan head to allow free movement.
each day for the device to operate.
ON
need to login to the image server
NOT
OFF
and when the alignment system is re-
ON
Chapter 3 - How to...
in use. Using the
NOT
or in standby mode.
Page 29 of 69
English