Shut Down The Scan Head; Install Software Updates; Log Off The Image Server Each Day; Restart The Image Server Each Week - Nikon Optos California P200DTx rg Manuel D'utilisation

You put the scan head into standby mode at the end of each working day.
MUST
1. End the current session and select
2. The status indicator will turn blue when the device is in standby mode. The touch screen will switch
when the device is in standby mode.
OFF
3. Place the fabric cover over the scan head after the scan head is in standby mode.

3.1.2.1 Shut down the scan head

You should usually have to shut down the scan head.
NOT
1. Follow the instructions to put the scan head into standby mode, see Use standby mode at the end of
each day on the previous page .
2. When the status indicator has turned blue you can turn
located at the at the back of the scan head. The

3.1.2.2 Install software updates

Each time you shut down the system the device will check for software updates. You should follow the
instructions displayed on the touch screen to start the software update.
The device shuts down when the updates have completed.

3.1.2.3 Log off the image server each day

You should log off the image server at the end of each day.
1. Exit OptosAdvance.
2. Select the "Windows" button.
3. Select Log off
.
Note
Image files cannot be viewed on browser-based review clients when the image server has been shut
l
down.
Restart the image server each week to allow updates to install, see Restart the image server each
l
week below .

3.1.2.4 Restart the image server each week

Exit OptosAdvance
CAUTION
You should restart the image server each week to allow updates to install.
1. Exit OptosAdvance.
2. Select the "Windows" button.
3. Select Restart .

3.1.3 Use the system

Before setting up and capturing images, ensure you are familiar with the device and equipment.

3.1.3.1 Using the touch screen

The touch screen is connected to the scan head and controls the scan head and capture functionality.
Some of this functionality is also available on the hand control, see Using the hand control on page 33 .
Part Number: G108025/4GCA
Copyright 2017, Optos plc. All rights reserved.
on the touch screen to put the device into standby mode.
OFF
position is marked "
OFF
before turning the image server.
OFF
Chapter 3 - How to...
the power supply. The power switch is
".
Page 31 of 69
English