Publicité
Les langues disponibles
Les langues disponibles
PAGE HEADER.....
OPERATING
AUTO PURGE
Immediately after the espresso, hot water
and steam functions, the machine will purge
water into the drip tray. This ensures the
thermocoil is at the optimal temperature.
TIP
Ensure the drip tray is firmly pushed
in place and emptied whenever the
Empty Me! indicator is displayed.
SLEEP & AUTO OFF MODE
The machine automatically switches to
SLEEP MODE after 1 hour. During this time,
the POWER button light will flash slowly.
After 3 hours, the machine will switch to
AUTO OFF MODE.
To re-activate the machine, press any button
except for the POWER button. The POWER
button light will flash while the machine
re-heats. A pumping sound will be heard.
This is normal. When the machine has
reached the correct operating temperature,
the POWER button light will stop flashing
and all button lights on the control panel
will illuminate.
ADVANCED TEMPERATURE MODE
Different beans require a different water
temperature to extract their optimum flavor.
The Infuser™ allows you to adjust water
temperature ±4°F in 2°F increments from the
default temperature.
To enter Advanced Temperature Mode:
Press the POWER button to switch
1.
the machine off.
Press & hold the 1 CUP button,
2.
then also press the POWER button.
The machine will beep once. The
illuminated button will indicate the
current temperature selected.
To adjust the water temperature,
press the 2 CUP button to cycle
through the temperature settings.
Default Temperature setting:
Press the 2 CUP button until the POWER
button illuminates.
Decrease Water Temperature -4˚F:
Press the 2 CUP button until the PROGRAM
button illuminates.
Decrease Water Temperature -2˚F:
Press the 2 CUP button until the
DESCALE/CLEAN light illuminates.
Increase Water Temperature +2˚F:
Press the 2 CUP button until the HOT
WATER/STEAM light illuminates.
Increase Water Temperature +4˚F:
Press the 2 CUP button until the 1 CUP
button illuminates.
The machine will beep twice to confirm
the change. If no buttons are pressed
within 10 seconds after entering Advanced
Temperature Mode, no change will be made
& the machine will return to STANDBY mode.
17
Publicité
