Dustbane Integra-D Manuel D'opération page 7

CAUSE
1. Worn pad
2. Worn isolators
CAUSE
1. Isolators worn
2. Component has come loose
Fast Track Kit Troubleshooting Guide
CAUTION: Always disconnect power cord before servicing.
WARNING: Repairs should only be performed by an authorized service center.
CAUSE
1. Cap is damaged
2. Faulty vacuum motor
3. Micro-Ply filter bag is full
4. Clogged hose or wand
5. Loose or broken fan
CAUSE
1. Faulty ON/OFF switch
2. Power cord defective
3. Loose connection or wiring
4. Motor defective
5. Blown fuse or tripped circuit breaker
CAUSE
1. Micro-Ply filter bag is full
2. Micro-Ply filter bag not installed properly
3. Cloth filter bag dirty
4. Cloth or Micro-Ply filter bag is torn
PROBLEM:
Machine pulls hard to the right
1. Replace pad
2. Replace isolators
PROBLEM:
Machine is unusually loud
1. Replace isolators
2. Tighten all screws, bolts, knobs
3. Replace foam pads where weights sit
PROBLEM:
Loss of suction
1. Inspect and replace if needed
2. Contact Dustbane or a service center
3. Replace Micro-Ply filter bag
4. Remove obstruction
5. Contact Dustbane or a service center
PROBLEM:
Motor is not running
1. Contact Dustbane or a service center
2. Contact Dustbane or a service center
3. Contact Dustbane or a service center
4. Contact Dustbane or a service center
5. Replace fuse or reset circuit breaker
PROBLEM:
Dust blowing from vacuum when running
1. Replace Micro-Ply filter bag
2. Reinstall or replace
3. Clean cloth filter bag
4. Replace
SOLUTION
SOLUTION
SOLUTION
SOLUTION
SOLUTION
7