Publicité
Les langues disponibles
Les langues disponibles
•
Sanding wood decks is not recommended by Dustbane due to uneven surfaces which could lead to damage
to the machine. Some pressure treated wood found in decking contains arsenic that, when sanded, will create
hazardous dust. Dustbane assumes no liability if the machine is used on decks, and damage caused from sanding
pressure treated wood will not be warranted.
•
Do not operate this machine around fuels, solvents, flammable floor finishes, thinners, wood particulate or any
flammable materials. Cigarette lighters, pilot lights, electrical sparks and all other sources of ignition should be
extinguished or avoided. Work areas should be well ventilated.
•
Keep the power cord clear of the pad. Always lift the cord over the machine. Do not pull on the power cord in an
attempt to move the machine. This could result in electrocution.
•
Do not use machine if it has been sprayed with water or left out in the rain. This could result in a shock, injury or
electrocution.
•
Keep feet, hands, and loose clothing away from any moving parts on the machine to avoid injury. Disconnect
power cord before changing the pad or when servicing. Damage can occur to the machine or to other property
if instructions in the owner's manual are not followed.
•
Do not operate this machine while under the influence of alcohol or other drugs.
•
Never allow children under age 18 to operate this machine.
•
Unplug machine from power source before adjusting height of handle or changing pad.
•
Servicing this machine while still connected to a power source could lead to electrocution or fire. Before
performing machine service or maintenance, disconnect the machine from its power source. Operating this
machine with a damaged power cord could lead to electrocution or fire. Cord should remain clear of moving
parts during operation. Never use the cord to navigate the machine.
Integra-D Troubleshooting Guide
CAUTION: Always disconnect power cord before servicing.
WARNING: Repairs should only be performed by an authorized service center.
1. Machine is not plugged
2. Socket breaker has been tripped
3. Motor breaker has been tripped
4. Faulty receptacle
5. Defective switch / wiring
1. Faulty receptacle
2. Faulty extension cord
3. Defective switch
4. Defective motor
1. Excessive weight for application
2. Faulty Breaker
3. Extension cord too long
6
Machine won't start
CAUSE
Runs unpredictably
CAUSE
Fuse / Breaker Trips
CAUSE
PROBLEM:
1. Check wall outlet and motor connection
2. Reactivate breaker
3. Press manual reset on motor box
4. Move to new receptacle
5. Contact Dustbane dealer
PROBLEM:
1. Move to new receptacle
2. Use new 10 gauge extension cord less than 25 feet
3. Contact Dustbane dealer
PROBLEM:
1. Reduce machine weight
2. Breakers in electrical panel need replacement by electrician
3. Move machine to new receptacle closer to worksite
SOLUTION
SOLUTION
SOLUTION
Publicité
