Publicité
Les langues disponibles
Les langues disponibles
Safety
Dustbane products are built to strict safety and reliability specifications in accordance with industry standards. Therefore, safety
issues pertaining to operation and repair of Integra-D equipment are primarily environmental and human interface. The following
basic safety tips are given to ensure safe installation, operation and maintenance of the Integra-D.
Transport of Machine
To transport this machine, the following procedure is advised:
•
Unplug machine from power source.
•
Unplug the motor from the handle.
•
Leave the buffer pad attached to the face grip as to not prematurely wear the machine.
•
Wrap cord using cord wrap and handle.
•
Unscrew the weight locking knobs and slide the weights out.
•
Unlock the locking cam by raising the handle to the vertical position.
•
Remove the two safety pins.
•
Remove the handle from the handle support and place aside.
•
The axle may be used as a carry handle.
•
The handle, base assembly and weights may be transported separately.
CAUTION: This machine is very heavy. Please disassemble machine prior to transportation off site. Get assistance when lifting the
base assembly. Do not attempt to lift alone.
General Operating Instructions
1.
Move machine to work location. Never operate, transport, or store the machine without a pad to protect the grip face.
2.
Plug machine into grounded power outlet.
3.
Stand behind the Integra-D and place your hands on the padded handle grips.
4.
Push the safety lever away from you with your thumbs and squeeze the trigger with remaining finger. The machine naturally and
gently rotates in a clockwise motion if left unmanaged. Please use both hands to operate the machine.
5.
Begin moving forward in straight lines.
6.
Best results are found when the handle is used in an upright position. However the handle may be tilted to suit your application.
Open the quick release cam handle and slide the pin into the desired stop. Always use the machine with the pin firmly in a stop.
Firmly close the cam with your hand. The cam lever must not be rotated to achieve tightness. Instead open and close the lever. A
tightness adjustment may be made on the locking nut opposite to the lever.
7.
Continue moving in straight lines, checking your pad every 15 to 30 minutes (depending on pad in use) to maintain optimum
performance.
Important
To reduce the risk of fire, electric shock or injury:
•
Never leave the machine unattended while power cord is connected.
•
Always wear personal protective equipment (PPE) when operating this machine.
•
Never inhale dust created by the use of this machine. Any modifications to this machine may result in damage
to the machine or injury to the operator or others nearby. Alterations to the machine will also void any and all
warranty and liabilities.
5
Publicité
