BONFIGLIOLI Vectron ACTIVE ANG 410-05 1 FA Guide Rapide page 127

7.2 Status messages during commissioning (SS...)
The following status messages are possible when Setup is run:
Status message
SS000 OK
SS001 PC Phase 1
SS002 PC Phase 2
SS003 STO
SS004 Parameter
identification
SS010 Setup already
active
SS030 No Release
SS031 Error – check P.
259
SS032 Warning Phase
Asymmetry
SS099 Setup not car-
ried out yet.
7.3 Warning and error messages during commissioning
(SA.../SF...)
Warning messages during guided commissioning
Code
SA000 No warning message present.
SA001 The value of the parameter
range of the frequency inverter The maximum reference voltage is indicated
on the nameplate of the frequency inverter.
SA002 For a three-phase motor, the calculated efficiency is in the limit range. Check
the values entered for parameters
and
Rated Mech. Power
SA003 The value entered for parameter
normal range (0.6 to 0.95). Check the value.
SA004 For three-phase motor, the calculated slip is in the limit range. Check the
values for parameters
07/20
Auto set-up routine has been carried out.
The plausibility check (PC) of the motor data is
active.
The calculation of dependent parameters is active.
The parameter identification requires release on
digital input STOA and STOB.
The rated motor values are checked by the param-
eter identification feature.
The setup routine via the control panel is being
carried out.
The parameter identification demands the control-
ler release on digital input STOA and STOB.
Error during the auto set-up routine. Check value
259.
of
Current Error
The parameter identification feature diagnosed an
unbalance during the measurements in the three
motor phases.
Self-setup has not yet been carried out.
Meaning / Measure
Rated Voltage
Rated Voltage
376.
Rated Cosinus Phi
372 and
Rated Speed
Quick Start Guide ANG
Meaning
370 is out of the rated voltage
370,
Rated Current
374 is outside of the
Rated Frequency
GB
371
375.
127