BONFIGLIOLI Vectron ACTIVE ANG 410-05 1 FA Guide Rapide page 121

240 Actual Speed
241 Actual Frequency
259 Current Error
269 Warnings
273 Application Warnings
310 Last Error
783 SETUP adjusted motor
parameters
CAN System Bus:
978
Node state
CAN System Bus:
979
CAN state
CANopen/DeviceNet:
1290
Node state
CANopen/DeviceNet:
1291
CAN state
6.2 Parameter setting options
Parameter
No. Description
28 Control Level
370 Rated Voltage
371 Rated Current
07/20
1/min Speed of the asynchronous machine calculated
using the machine model and the current load
point.
Hz The current output frequency of the frequency
inverter or actual frequency of the drive calculated
from the machine model.
- The cause of the error-switch-off and the corre-
sponding error key are displayed. The current
error is used for error diagnosis.
- If a critical condition is detected, this condition is
indicated by the field WARN. The warning status
can be displayed via parameter 269.
- An application-specific warning can be read. For
detailed functions, refer to Operating Instructions.
- The fault message is displayed immediately when
a fault occurs. The frequency inverter will try to
acknowledge some faults automatically, other
faults will be reset via digital input S1IND. The last
fault code is saved for fault diagnosis.
- The listed parameters (separated by commas)
were changed by motor commissioning.
If SETUP was not carried out yet, "No parameters
adjusted" will be displayed.
-
Parameter
Node-State
about the status (Pre-Operational, Operational,
Stopped) of the System Bus.
-
Parameter
CAN-State
about the state of the physical layer of System
Bus.
-
Parameter
Node-State
mation about the status (Pre-Operational, Opera-
tional, Stopped) of CANopen.
-
Parameter
CAN-State
about the state of the physical layer of CANopen.
Min.
1
0.17⋅U 1)
FUN
0.01⋅I 1)
FUN
Quick Start Guide ANG
978 provides information
979 provides information
1290 provides infor-
1291 provides information
Setting
Max. Factory setting
3
2⋅U 1)
FUN
10⋅ü⋅I 1)
FUN
GB
1
U 1)
FUN
I 1)
FUN
121