F1 Off" - Setting Display Backlighting, Acoustic Alarm And Units Of Measure; F2 Prt" - Printer Configuration; U Id" - Setting User Id - Dini Argeo BCSD Serie Manuel Opérateur

7.2 "F1 oFF" – SETTING DISPLAY BACKLIGHTING, ACOUSTIC ALARM AND UNITS OF MEASURE
bEEP ACOUSTIC ALARM
on oFF acoustic alarm disabled
on in active acoustic signal with active "OK" symbol.
on oUt active acoustic signal with active "HI" or "LO" symbol.
EL DISPLAY BACKLIGHTING
oFF backlighting always off
on backlighting always on.
AUt backlighting on only when the weight is greater than 20d or when a key is pressed. When a key is pressed,
if the weight is less than 20d, the backlighting remains active for 5 seconds.
Unit UNIT OF MEASURE
Trough this step it's possible to select the units of measure usable in the weighing phase (see section 6.2).
kG/Lb "kg" and "lb" units both active
kiLo only "kg" unit active.
Lb only "lb" unit active.
oFF AUTO SWITCH-OFF
By pressing TARE one sets the minutes of not being used for the auto switch-off (see section 6.12):
0 (disabled)
3 (3 minutes of not being used)
5 (5 minutes of not being used)
15 (15 minutes of not being used)
30 (30 minutes of not being used)
7.3 "F2 Prt" – PRINTER CONFIGURATION
P ModE TRANSMISSION MODE
Print transmission when totalisation is made or upon request through serial command.
By selecting this mode one will be asked to select the totalisation mode:
AU oFF Manually through the M+ key.
AU on
P Cont continuous transmission with P Cont. protocol
SEr rE continuous transmission with SEr rE. protocol
For the description of the transmission modes refer to section 9.1.
P bAUd TRANSMISSION SPEED
Press the U.WT/UNITS key to select one of the possible speeds : 600, 1200, 2400 4800, 9600.
PAritY SETTING PARITY, WORD, STOP BIT
Press the U.WT/UNITS key to select one of the possible values: 8 n 1, 7 E 1, 7 o 1.
PtYPE PRINTER TYPE
tPuP enables the printing with ASCII printer (for example TPR).
LP50 Non used in this application.

7.4 "U id" - SETTING USER ID

By pressing TARE it's possible to enter or modify the USER ID, in other words, a text of 6 characters which can be
printed or recalled through the serial line (see section 9.2.3).
To enter the text refer to section 6.10.
Automatically upon weight stability
14