Manual Or Automatic Totalization; Checking Quantities; Setting The Check On The Weight Or The Pieces And Of The Weight Thresholds; Acoustic Alarm In Correspondence Of The Hi-Ok-Lo Limits - Dini Argeo BCSD Serie Manuel Opérateur

NOTE:
- The automatic totalisation functions with a minimum weight of 20d.
- The maximum number of totalisations is 99 while the maximum total value which may be accumulated is 999999.
Once reached these limits, one should clear the total; by pressing M+ the message "AdErr" will appear on the
display.
- The total values will be cleared when it's turned off.

6.8.1 MANUAL OR AUTOMATIC TOTALIZATION

The operation of accumulation, normally done manually with key M+, can be done automatically when the weight is
stable. To printout the data relatives to the totalized weight, unload the weight from the scale. In regards to the choice
of the totalisation execution mode see section 7.3.

6.9 CHECKING QUANTITIES

The scale is fitted with the quantity check function with 2 weight thresholds. An acoustic alarm and three reference
symbols on the display are enabled on the basis of the set thresholds and the weighing result.

6.9.1 SETTING THE CHECK ON THE WEIGHT OR THE PIECES AND OF THE WEIGHT THRESHOLDS

Press PST:
- The "WEIGHT" display shows "Pst" while The "UNIT WEIGHT" display shows the type of control; use the
U.WT/UNITS to set the control on the net weight (nEt) or the control on the pieces (Cnt).
- Confirm the entered value with TARE or press ZERO to exit without confirming.
- The "WEIGHT" display shows "Hi nEt" or "Hi Cnt" while The "UNIT WEIGHT" display shows "000.000". In this step
one configures the upper threshold.
- Use the numeric keys to enter the desired value
- Confirm the entered value with TARE or press ZERO to exit without confirming.
- The "WEIGHT" display shows "Lo nEt" or "Lo Cnt" while The "UNIT WEIGHT" display shows "000.000". In this
step one configures the lower threshold.
- Use the numeric keys to enter the desired value
- Confirm the entered value with TARE or press ZERO to exit without confirming.
- The thresholds are configured and the indicator returns to weighing.

6.9.2 ACOUSTIC ALARM IN CORRESPONDENCE OF THE HI-OK-LO LIMITS

One can decide if the acoustic alarm should enable when the "OK" symbol is on or when the "HI" or "LO" symbols are
on. To choose the alarm enabling mode, see "bEEP" step, section 7.2.

6.9.3 VISUAL INDICATION OF THE WEIGHT CHECK

Put a weight on the plate of the scale.
The indication symbols will enable depending on which thresholds have been configured:
WITH BOTH THRESHOLDS CONFIGURED
- The HI symbol of the "COUNT" display will turn on when the detected value exceeds the UPPER THRESHOLD.
- The OK symbol of the "COUNT" display will turn on when the detected value is between the LOWER
THRESHOLD and the UPPER WEIGHT THRESHOLD.
- The LO symbol of the "COUNT" display will turn on when the detected value is less than the LOWER
THRESHOLD.
WITH THE UPPER THRESHOLD CONFIGURED AND THE LOWER THRESHOLD = 0
- The OK symbol of the "COUNT" display will turn on when the detected value exceeds the UPPER THRESHOLD.
- The LO symbol of the "COUNT" display will turn on when the detected value is less than the UPPER
THRESHOLD.
WITH THE UPPER THRESHOLD = 0 AND THE LOWER THRESHOLD CONFIGURED
- The HI symbol of the "COUNT" display will turn on when the detected value exceeds the LOWER THRESHOLD.
- The OK symbol of the "COUNT" display will turn on when the detected value is less than the LOWER
THRESHOLD.
11