Vertical Operation Of The Band Saw - HOLZMANN MASCHINEN BS 115 Mode D'emploi

15.3.2 Vertical operation of the band saw

Raise the arm band saw in the 90 ° position and
clamp it on the base console with the fixing bracket.
Remove the protective cover.
protective cover
The work talbe with the two screws attach on the
bandsaw blade guide.
Loosen the fixing screw at the bandsaw blade guide.
Insert the support bracket by the fixing screw
Screw on the table top with the countersunk screw
up and the washer and nut below.
The top bandsaw blade guide by unscrewing the
fixing nut (12) and screw into the threaded hole 2 be
pushed deeper.
As a result, the bandsaw blade is made even better.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
Work table for
vertical sections
support bracket
fixing screw
BS115 / BS128HDR
49