Lubrication; Cleaning; Disposal - HOLZMANN MASCHINEN BS 115 Mode D'emploi

16.4 Lubrication

Ball bearings do not require lubrication.
Lubricate the threaded rod of the jaw as needed
Cover all unpainted surfaces regularly with a thin layer of light-Maschi machine oil.
The transmission runs in an oil bath and requires about 1 time per year for an oil change:
Bring to the saw arm in horizontal position.
Remove the four screws of the gear cover and remove the cover.
Place a drain pan under the transmission housing.
Lift the saw arm out so that the oil flows.
Clean the gear case of coarser waste oil residues, fill a new TRANSMISSION OIL, and install the
cover properly.
Dispose of the used oil ecologically.

16.5 Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces
as well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution

16.6 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTICE
MAINTENANCE
56
BS115 / BS128HDR