HOLZMANN MASCHINEN BS 115 Mode D'emploi page 51

Example of a perfect adjustment of the bandsaw blade guide:
The bandsaw blade has too much play and is
therefore still cannot between the lateral
bearing rollers.
CAUTION:
Before tightening the bandsaw blade guide examine whether the saw band
is below set perfectly vertical and readjust the bandsaw blade guide
according vertically.
The bandsaw blade guide with the screw for fixing tighten.
NOTE: Check the 90 ° bandsaw blade guide with an angle gauge or with a rectangular
workpiece.
Repeat this process on the right if the saw band saw
blade guiding is not performed exactly vertical.
NOTE: The bandsaw blade guide slide (left / right) as
close as possible to the workpiece.
By loosening the fixing nuts (12), the blade guides
can be moved.
CAUTION: Bevel cuts are resulting from not exactly vertical set saw blade guides and too much
play between the lateral bearing rollers!
Perform all the conversion work in isolation from the mains!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
The saw blade is completely vertically without any
play between the lateral bearing rollers.
WARNING
OPERATION
51
BS115 / BS128HDR