Accessories - Scheppach AB1900 Traduction Des Instructions D'origine

• All moving parts are to be re-greased at
periodic intervals.
• Do not use detergents or solvents as
these might damage the plastic parts of
the device. Make sure that no water can
get inside the device.
Carbon brushes
In case of excessive sparking, have the
carbon brushes checked by a qualified
electrician.
Caution! The carbon brushes should be
replaced only by a qualified electrician.
Check the oil level
The oil level should be checked before
each use of the device.
Place the device with the tool holder in the
down position on the floor. The oil must be
aligned with the marked cross. Refill with
oil if necessary.
Oil change: Fig.5
The oil should be changed after about 40-
50 hours of operation.
Recommended oil: 100 ml SAE 15W/40 or
similar.
Caution! Switch off the device. Discon-
nect the mains plug!
1. Lay the device on its back. Unscrew
the sight glass (4) by opening the four
tapping screws (11).
2. Empty the old oil by tilting it into a suit-
able container.
Note: Waste oil must be disposed of
at the appropriate collection point
for used oil!
3. Fill in the new oil (about 100 ml) into the
oil filler opening.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Heruntergeladen von manualslib.de Handbücher-Suchmachiene
4. Tighten the sight glass again and check
the oil level. Refill or remove oil if nec-
essary.
5. Check the oil level again after a short
period.
Service information
Please note that the following parts of this
product are subject to normal or natural
wear and that the following parts are there-
fore also required for use as consumables.
Wear parts* all chisels, carbon brushes
* Not necessarily included in the scope of
delivery!

13. Accessories

Flat chisel
Art.No.:
3908201108
Barcode:
4046664014287
Point chisel
Art.No.:
3908201109
Barcode:
4046664014294
GB | 31