Telecom Behnke 20 Serie Instructions page 54

Code Parameter
Additional amplifier: Default setting: 0
07 0 = inactive
1 = low
:
9 = very loud volume
Please note: We advise to use a value from 1 to 4 for this setting.
Operation modes Relay 1: Default setting: 6
08 0 = inactive
1 = to be activated via the telephone
2 = to be activated via the keypad
3 = to be activated via both the telephone and the keypad
4 = to be activated via the telephone & disconnecting after activation
5 = to be activated via the keypad & disconnecting after activation
6 = to be activated via both the telephone and the keypad & disconnect-
ing after activation
7 = activated during outgoing calls
8 = activated during incoming calls
9 = activated during both incoming and outgoing calls
10 = activated at the beginning of an outgoing call
11 = activated at the beginning of incoming calls
12 = activated at the beginning of both outgoing and incoming calls
13 = activated while ringing
14 = activated during interference (failure in telephone line)
15 = to be activated via the emergency call control centre
16 = activated during a direct call via button 1 (from V1.20 or later)
17 = activated at the beginning of a direct call from button 1 (from V1.20 or
later)
18 = manually activated (from V1.30 or later)
19 = automated activation according to the time table (cf. configurations
step 43) (from V1.30 or later)
20 = activated after placing an emergency call (according to EN 81-70)
(from V1.40 or later)
21 = activated while speaking in two-way communication (from V1.42 or
later)
22 = activated while listening in two-way communication (from V1.42 or
later)
www.behnke-online.com
Manual Door intercom devices a / b Series 20 / 30 / 50
Configuration and Set-up
GB
Confirmation
#
#
:
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
#
54