Telecom Behnke 20 Serie Instructions page 45

Manual Door intercom devices a / b Series 20 / 30 / 50
GB GB
Installation
Connect the ribbon cable connection to the
built-in modules (speaker, microphone, buttons
etc.)
Connector pin assignment for connection wires
Series 20, 30, 50
LP (blue)
▸ speaker
Mik (white) ▸ microphone
T1 to T8 (yellow)
12-pin connector
HPI contact (white)
(cf. also item
Please note: Use the ribbon cable to connect
existing components. Use a cable binder to tie
unused cables together (plugs face down).
Latch the electronics box back
onto the module housing.
45
▸ button 1 to 8
▸ number keypad
▸
label area
)
Electronics box
T1 T
T2 T
T3 T
Module housing
www.behnke-online.com