Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. ASSEMBLY:
After installation of the housing and the clamp, if it Is a prefabricated swimming pool, assemble the floodlamp.
To connect the floodlamp to the electric power supply Insert the cable through the gland seal nut (25). Tíghten the gland seal nut
until you can verify that the cable wlil not yleid when you pulí on it wlth your hand.
Take the precautlon of leaving 1.5 m of cable wound on the floodlamp houusing(Nº 18) in order to be able to remove the floodlamp
to the edge of the pool in the event that lamp replacement or handiing is required. (Fig. 5).
Insert the entire floodlamp assembly in the housing (Fig 6). In order to ofatain good pool lighting it ¡s important that the anagram of
the decorative ring (Nº 1) is located on the upper part (Fig 7).
Screw in the two M-6 x 80 screws (Nº 2) until the fastening dog is secured in the inner walls of the housing (Fig. 8)
5. MAINTENANCE:
This projector does not require any type of maintenance. If the projector does not work properly, please contact our customer
attention department.
It is forbidden to handle the inside of the projector. All projectors which have been handled will lose their guarantee.
If you wish to remove the projector from the swimming pool, it must be done by suitably qualified technician.
To remove the floodlamp to the edge of the swimming pool (Fig. 5) loosen the two DIN 966 M-6 x 80 screws (Nº 2) untll the
fastening dog ylelds sufficlentiy so that the floodlamp unlí can be separated from the housing.
Attention:
• Before any handiing ensure that there is NO voltage supplied to the floodlamp.
6. CONTROL SYSTEMS OF THE LED PROJECTORS:
The LED projectors can be controlled in two different ways: either by a normally closed pushbutton or by means of the modulator
receiver and/or remote control
In both cases, you should make sure that the voltage received by the lamp is never more than 12V.
The projector should only be operated underwater and anchored to the vertical walls of the pool. The spotlight is supplied with heat
protection, which in the event of excess temperature reduces the lighting level to avoid overheating.
6.1. Colorplus ECO: pushbutton control
The system has 14 operation modes: 7 set colours and 7 sequences of different colours (see section 6.1.2.) The colour or sequence
is changed by a quick press of the pushbutton. The projector/s is/are placed in white if the pushbutton is pressed for longer.
6.1.1. Electrical connection diagram
The Color Plus Eco system is composed of the projector/s, the transformer and the normally closed (NC) pushbutton.
The transformer must be able to supply 45VA for each led spotlight connected. For example, if you want to control 6 spotlights, you
must connect them in parallel to a transformer of at least 270VA. The pushbutton must be able to withhold the power consumed by
the number of projectors installed.
6.1.2. Operation modes
The Colorplus ECO unit enables different light scenarios to be created inside the swimming pool with two operation possibilities:
Set colour: Selection of one set colour out of seven possibilities.
COLOUR Nº
% RED
1
100
2
100
3
0
4
0
5
100
6
0
7
100
% BLUE
% GREEN
100
100
0
0
100
0
0
100
100
0
100
100
0
100
COLOUR
White
Red
Blue
Green
Purple
Cyan
Yelow
Publicité
Table des Matières
