Electrical Connection Diagram; Operation Modes - Astralpool 41636 Manuel D'installation Et D'entretien

D. Drill the 10 holes of the anchorage bolts, which should be suitable to the base material. The bolts should be 8 mm. in diameter.
E. Insert the anchorage bolts and tighten the projector.
F. Direct the projector as required. To do so, loosen the 6 screws indicated in figure 4,
place the projector in the required position and tighten the screws.
G. Connect the projector to the mains. (It is recommended to use the vulcanising kit
code 32803)
5. MAINTENANCE:
This projector does not require any type of maintenance. If the projector does not work properly, please contact our customer attention department.
THIS PRODUCT DOES NOT CONTAIN ANY ELEMENTS THAT CAN BE HANDLED, DISMANTLED OR REPLACED BY THE USER. IT IS FORBIDDEN
TO ACCESS INSIDE THE PRODUCT, OTHERWISE THE GUARANTEE OF THE PRODUCT WILL BECOME INVALID.
CLEANING
Do not use abrasive products, acid-based products such as bleach, solvents, acetone, etc. to clean the projector.
Clean it with a damp cloth. If you want to use soap, dilute in water with a low concentration. Finally use a dry cloth and the projector will be clean.
6. CONTROL SYSTEMS OF THE LED PROJECTORS:
The LED projectors can be controlled in two different ways: either by a normally closed pushbutton or by means of the Modulator and/or Remote
Control.
In both cases, you should make sure that the voltage received by the lamp is never more than 12V.
The projector should only be operated underwater and anchored to the vertical walls of the pool. The spotlight is supplied with heat protection, which
in the event of excess temperature reduces the lighting level to avoid overheating.
6.1. Colorplus ECO: pushbutton control
The system has 14 operation modes: 7 set colours and 7 sequences of different colours (see section 6.1.2.) The colour or sequence is changed by a
quick press of the pushbutton. The projector/s is/are placed in white if the pushbutton is pressed for longer.

6.1.1. Electrical connection diagram

The Color Plus Eco system is composed of the projector/s, the transformer and the normally closed (NC) pushbutton.
The transformer must be able to supply 60VA for each led spotlight connected. For example, if you want to control 5 spotlights, you must connect
them in parallel to a transformer of at least 300VA. The pushbutton must be able to withhold the power consumed by the number of projectors
installed.

6.1.2. Operation modes

The Colorplus ECO unit enables different light scenarios to be created inside the swimming pool with two operation possibilities:
Set colour: Selection of one set colour out of seven possibilities.
Automatic sequence of colours: Selection of nine colour sequence programmes. Each programme is defined by the lighting time of each colour and
the transition time from one colour to another according to the following table:
COLOUR Nº COLOUR
1 White
2 Red
3 Blue
4 Green
5 Purple
6 Cyan
7 Yelow
3
Fig. 4