Astralpool 27820 Manuel D'installation Et D'entretien page 4

Automatic sequence of colours: Selection of nine colour sequence programmes. Each programme is defined by the lighting time of
each colour and the transition time from one colour to another according to the following table:
SEQUENCE
1 Red
2 Red
3 Purple
4 Red
5 Purple
6 Yelow
7 Green
The colour or sequence is changed by pressing the pushbutton. The colour and sequence cycle is rotary. For example, if you are in
colour 5, by pressing once, you will reach colour 6. If you press once again, you will go to sequence 7. If you are in sequence 7,
press once and you will get to colour 2, which is Red.
Colour 1, corresponds to white and is reached by one long press.
6.2. COLOR PLUS TOP: Receiver-Modulator control and/or Remote control
The system has 21 operation modes: 12 set colours and 9 sequences of different colours (see section 6.2.2.).
The Receiver-Modulator controls switching the spotlights on and off, changes of colour and sequences and switching off timing.
If you have a remote control, apart from the receiver-modulator operations, you can also switch colours of a sequence on and off and
select the switching off time.
6.2.1. Electrical connection diagram
For correct installation, you will need the Receiver-Modulator, the transformer and finally the leds lamp. As an option, this system
can be controlled by Remote Control. For more information on the installation of the Receiver-Modulator, see point 6.2.3. and section
6.2.4. includes information on the Remote Control.
The Receiver-Modulator is connected to the 230 Vac mains by means of two terminals indicated MAINS, and to the primary input of
the transformer (230 Vac) by means of the terminals indicated TRF (See attached diagram).
Each Receiver-Modulator, it can control until a maximum of five spotlights.
The transformer must have the capacity to supply 45 VA to each led spotlight connected. For example, if you want to control 5
lamps, they should be connected in parallel to a transformer of at least 270VA.
Each Receiver-Modulator can control up to a maximum of 15 LED spotlights.
Once the unit is connected, proceed as follows to start-up the projector for the first time:
• Switch on the unit by activating the 230 Vac. at the input of the Receiver-Modulator, which will automatically syntonize with the
transformer. The green led of the Receiver-Modulator will flash every 2 seconds and the spotlight will remain off.
• Switching on the Remote control
o Keep the OFF key pressed of the Receiver-Modulator. The green led will flash quickly indicating that it is in the Instruction
mode.
o Switch on the Remote Control and press any button. If you have several Remote Controls, repeat the operation so that the
Receiver-Modulator acknowledges them all. There can be a maximum of eight.
6.2.2 Types of lighting
The Remote Control – Receiver/Modulator – Transformer – Led Projector unit enables you to create different lighting settings inside
the pool with two operation options:
Set colour: Selection of a set colour among twelve possibilities.
ORDER OF COLOURS
Blue Green Purple
Green Cyan Blue
Cyan Yelow -
Blue Green -
Cyan Yelow -
Purple Cyan -
Red Blue -
COLOUR TIMING
Cyan Yelow
Purple Yelow
- -
- -
- -
- -
- -
BLENDING TIMING
(SEC.) (SEC.)
2
4
4
8
18
0,5
0,5
2
4
4
8
18
0,5
0,5