Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
COLOUR Nº
1
2
3
4
5
6
7
8
9
10
11
12
Automatic sequence of colours: Selection of nine colour sequence programmes. Each programme is defined by the lighting time of
each colour and the transition time from one colour to another according to the following table:
For example, programme 5 indicates that each colour will stay for 30 seconds, out of which 22 seconds will be with one set colour
and the remaining 8 seconds are used in the transition to the following colour. Programme 8 indicates that the 60 seconds
corresponding to each colour are used in the transition to the following colour.
The colours used in the sequence can be selected from the 12 set colours. Proceed as follows to include them in the sequence:
• Press the COLOUR key in the remote control. The colour number will be displayed preceded by the letter "C".
• Press the ACTIVATION key and the letter "C" will alternately switch from an upper case letter to a lower case letter.
• The colours activated with the upper case "C" will form part of the sequence.
NOTE: The spotlight is equipped with a heat protection device that, in the event of excess temperature, reduces the lighting level to
prevent overheating.
6.2.3 Receiver-modulator (code 27818)
Install the Receiver-Modulator where it is protected from corrosion, outside metal boxes and at a
distance from metal pipes or electrical cables that can block the Radio Frequency signal from the
remote control.
Operation of the Pushbuttons:
OFF:
• To turn off the spotlight.
• By keeping this button pressed (whether the spotlight is on or off), the receiver enters the
"Instruction" mode, that starts-up the remote control by pressing once any key of the
Control (See "Start-up").
ON / COLOUR:
• If the spotlight is off or in the SEQUENCE mode, the spotlight is turned on in the SET COLOUR mode (the activated colour
will be the last set colour used).
• If the spotlight is already in the SET COLOUR mode, press the button to change the colour within the 12 different options.
ON / SEQUENCE:
• If the spotlight is off or in the SET COLOUR mode, the spotlight is switched on in the SEQUENCE mode. (The activated
programme will be the last one used) (programme or colour changes in the sequence should be performed from the remote
control).
ON / TIMER:
• If the spotlight is off, it is switched on in the last operation mode used and the TIMER function is activated, switching it off
automatically after a time pre-set from the remote control. (duration changes of the timer must be performed from the remote
control).
• If the spotlight is in SET COLOUR or SEQUENCE mode, the TIMER function is activated.
% RED
% BLUE
100
0
0
100
0
0
100
50
100
0
0
100
0
50
100
100
0
100
100
0
100
100
100
50
COLOUR TIMING
SEQUENCE
(SEC.)
1
4
2
8
3
15
4
15
5
30
6
30
7
60
8
60
9
120
% GREEN
COLOUR
0
0
100
0
Magenta
50
Light yellow
50
Bluish cyan
100
Greenish cyan
0
100
100
50
Bluish white
100
Greenish white
BLENDING
TIMING (SEC.)
1
8
4
15
8
30
15
60
60
Red
Blue
Green
Purple
Cyan
Yellow
Publicité
Table des Matières
