Description; Operation - Dustcontrol DC 1800 Manuel D'instruction

Description

The machine should be used for suction and separa-
tion of dried dust. The machine fulfi l the demands
for separation of unhealthy dust.
The DC 1800 is, despite it's compact size, a full ca-
pacity Dustcontrol machine. It is stable, tough and
reliable and particularly suited to spot extraction in
many different applications ie: welding, grinding,
sanding and cleanup with the 38 mm program.
Dust separation is in any case as effi cient as with the
larger Dustcontrol machines.

Operation

DC 1800 (Part no.1343330C30,
1343430c30, 1343350C30,
1343310C30, 1343430c31) Connect
the unit to a suitable power source,
note requirements on the ID plate. If
an extension cord is to be used, only
waterproof cords are acceptable.
DC 1800 Autostart:
(Part no, 1343330C31, 1343350C31,
1343310C31, 1343320CF1) Connect
the subject electric tool to the elec-
trical outlet on unit. Set the selector
switch to the AUTO position. The
unit will start automatically when the
subject tool is started. For manual
start of the unit, set the selector switch to the MAN
position.
The DC 1800 is equipped with a fi lter indication lamp
that indicates when the fi lter needs cleaning or chang-
ing. The fi lter is genereally cleaned once or twice daily
during normal continuous operation. The unit must
be in operation to perform fi lter cleaning. Loose the
tube from the suction pipe and press the plastic cage
against the black stop head on the exhaust channel so
that maximum pressure is created in the cyclone.
Open the port on the side o the unit three to six times.
This reverse pulse of air cleans the fi lter.
The machine can be used both with or without col-
lection sack.
DC 1800, 2008-04-23
The design is ergonomic and appealing. With a very
low sound level of 68 dB(A) at 1m distance, the
DC 1800 is suitable for use in areas which are sen-
sitive to noise. The direct drive two stage high pres-
sure fan is integrated into the units top. The 1400 W
capacity fan is double insulated for higher safety.
The collection sack should only be changed after the
cleaning of the fi lters. The collection sack must be
tied off when it is removed from the container. Use
only original Dustcontrol spare parts. There should
not be any fold on the container border. The tight-
ness make that the sac does not being sucked.
When remounting the motor top and the cyclone
on the container the hose inlet should be pointed
according to the picture beside.
For best result:
-Secure that no air is between the bag and the
barrel when you apply the bag.
-Secure that no air is leaking between the bag and
the barrel when you are using the machine.
10
Part No 94114