Description; Operation - Dustcontrol DC 2800c Manuel D'instruction

Description

The machine should be used for suction and separa-
tion of dried dust. The machine fulfi l the demands
for separation of unhealthy dust.
The DC 2800c is, despite it's compact size, a full
capacity Dustcontrol machine. It is stable, tough and
reliable and particularly suited to spot extraction in
many different applications ie: welding, grinding,
sanding and cleanup with the 38 mm program.
Dust separation is in any case as effi cient as with the
larger Dustcontrol machines.

Operation

Connect the unit to a suitable power
source, note requirements on the ID
plate. If an extension cord is to be used,
only waterproof cords are acceptable.
The DC 2800c is equipped with a fi lter
indication lamp that indicates when
the fi lter needs cleaning or changing.
The fi lter is generally cleaned once or
twice daily during normal continuous
operation. The unit must be in operation
to perform fi lter cleaning. Loose the
tube from the suction pipe and press
the plastic cage against the black stop
head on the exhaust channel so that
maximum pressure is created in the
cyclone.
Open the port on the side of the unit three to six times. This reverse pulse of air cleans the fi lter.
The plastic sack should be changed only after fi lter cleaning is done and when the collected material
level is about 5 cm under the foot valve.
Use only original Dustcontrol spare parts.
2008-04-09
The design is ergonomic and appealing. With a very
low sound level of 70 dB(A) at 1 m distance, the
DC 2800c is suitable for use in areas which are sen-
sitive to noise. The direct drive two stage high pres-
sure fan is integrated into the units top. The 1 200 W
capacity fan is double insulated for higher safety.
DC 2800c, 10
Part No 94112