Other Settings (Param) - Endress+Hauser RIA141 Manuel De Mise En Service

7.3.3 Hysteresis
LIMIT É HYST É Options -19999 to 99999
For entering the hysteresis for the threshold with minimum/maximum safety.
– Value range: -19999 to 99999
– Default 0
7.3.4 Response delay
LIMIT É DELY É Options 0 to 99 s
For setting the response delay (in seconds) of the limit value event after reaching the switching
threshold
– Value range: 0 - 99 s
– Default 0
7.4

Other settings (PARAM)

7.4.1 User code - locking
PARAM É CODE É User code entry
The device can be locked to protect the processes against undesired and unauthorised effects. The
device parameters are protected by a 4-digit user code and cannot be altered without entering the
code.
User code: a user code already assigned can only be altered if the old code is entered to enable the
device. The new code can then be configured.
• Value range: 0000 to 9999
• Default: 0
7.4.2 Program information
Name
Program name 'PNAME'
Software version 'SW-ID'
!
Note!
Press the + or - key to scroll horizontally through the 7 or 8-digit display values.
Description
Displays the name of the software loaded in the device (7-digit)
!
Note!
Display cannot be edited
Displays the version of the software loaded in the device (8-digit)
!
Note!
Display cannot be edited
Device configuration
55