4. ASSEMBLY INSTRUCTIONS
These should be placed on top of the lower corner pieces you previously
fitted so that part X of the profile of the side corner pieces overlaps the
corresponding part Y of the profile of the lower corner pieces (fig. 12a
and 12b);
Fig. 12a
X
Fig. 12b
13) Fit the left and right side caps, inserting them in the aluminium pro-
files featured on the edges of the collector and pushing them towards
the upper part of the collector (fig.13);
Fig. 13
32
14) Starting on the right, fit the upper corner pieces, hooking them onto
the profile on the upper part of the collector (fig. 14).
Fig. 14
The same should be inserted into the centre of one another (fig. 14a);
Y
Fig. 14a
The two upper corner pieces should overlap the side ones (see fig. 12b);
GB
GB