Charging; Operation - SilverCrest SAS 7.4 LI C2 Mode D'emploi

Masquer les pouces Voir aussi pour SAS 7.4 LI C2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34

Charging

NOTE
Ensure that the on/off switch
ance is switched off) before starting the charging process.
Place the handheld vacuum cleaner from above into the wall bracket
that the barrel plug
The charge indicator lamp
When charging is complete, which can take around 5 hours with fully dis-
charged batteries, the appliance automatically switches to a trickle charge
(maintenance function). The charge indicator lamp
Nevertheless, in order to avoid possible damage to the batteries, do not
leave the appliance permanently connected to the mains adapter
Do not recharge the batteries again until the handheld vacuum cleaner's
suction power becomes appreciably weaker and the charge indicator lamp
flashes green.
NOTE
If the handheld vacuum cleaner is deep-discharged, the charge indicator
lamp
switch off the appliance and start charging.
The handheld vacuum cleaner can also be charged directly via the mains
adapter
wall bracket

Operation

CAUTION!
The suction opening must always be open and may not be blocked. Block-
ages lead to overheating and damage to the motor.
NOTICES
Make certain that the dust filter
appliance.
When vacuuming liquid, do not exceed the MAX marking in dirt container
1) Remove the handheld vacuum cleaner from the wall bracket
not using the wall bracket
2) If required, place the appropriate nozzle in the suction opening.
The crevice tool
accessory storage in the handle (fig. 3).
the crevice nozzle
the wet suction nozzle
SAS 7.4 LI C2
5
slips into the socket on the handheld vacuum cleaner.
7
7
flashes alternately red and green (approx. 1 minute). In this case,
4
. To do this, remove the barrel plug
3
and insert it into the socket on the handheld vacuum cleaner.
3
2
and the wet suction nozzle
2
, to clean narrow and difficult to reach locations.
1
6
has been pushed back (and thus the appli-
lights up red and the charging process begins.
7
5
with a slight twist from the
0
is always inserted before using the
remove the barrel plug
1
are kept in the space-saving
to vacuum up liquids.
3
so
lights up green.
4
.
7
q
.
3
or, if you are
5
from the socket.
GB │ IE
 9

Publicité

Table des Matières
loading

Table des Matières