Zephyr ARC Serie Instructions D'installation Et D'utilisation page 15

Function is enabled. Filter Clean Indicator will continuously blink after 120 hours of unit fan
usage indicating it is time to replace the charcoal fi lter. Indicator light will blink, it will not
remain illuminated.
- This function must be reset by the user. With hood off, hold the Delay Off Button for fi ve
seconds, after fi ve seconds the Filter Clean Indicator will stop blinking and turn off and the
120 hour timer will reset.
Order replacement charcoal fi lter kit number Z0F-01AC through your local dealer, www.
zephyronline.com or the Zephyr customer service department.
- To disable Charcoal Filter Replacement Function:
- With hood off, hold Fan Speed and Delay Off buttons simultaneously for 5 seconds.
Filter Clean Indicator will illuminate for 3 second then turn off indicating the Charcoal Filter
Replacement Function is disabled.
I: Delay off indicator
- Delay Off Indicator will light up when Delay Off Function is activated by pressing the
- Delay Off Button.
- Delay Off Indicator will turn off after the Delay Off Function has completed the fi ve minu-
te cycle or if the user presses the Delay Off Button again or the Power Button.
E: Clean air indicator
- Clean Air Indicator is disabled by default and must be enabled by the user.
- To enable Clean Air Function:
- With hood off, hold the Power Button down for fi ve seconds. Clean Air Indicator light will
illuminate, and the fan will turn on low speed for 10 minutes. After 10 minutes the fan will
turn off and the 4 hour timer will begin. Clean Air Indicator will remain on when Clean Air
Function is enabled, even if fan is not on. When Clean Air Function is enabled, every four
hours of non fan usage the fan will automatically turn on at low speed for 10 minutes. After
10 minutes the fan will turn off and the 4 hour timer will reset. When the Clean Air Function
automatically turns the fan on the Clean Air Indicator will blink and the Low Speed fan
indicator will illuminate. If the user changes the fan speed while the Clean Air Function is
operating, the Clean Air Indicator will stop blinking but will remain illuminated. When the
user manually turns the hood off the 4 hour timer will reset.
- To disable Clean Air Function:
- With hood off, hold Power Button down for fi ve seconds until Clean Air Indicator light
turns off.
Note1: Changing the fan speed and interrupting the Clean Air Function while it is operating
does not disable the Clean Air Function. Clean Air Function will only be disabled by holding
the Power Button for 5 seconds.
Note 2: Turning lights on/off does not disable the Clean Air Function.
F: Fan Speed indicator
- 1 = Low
- 2 = Medium
- 3 = High
- On speed low, only number 1 indicator will be on.
- On speed medium, 1 and 2 indicator will be on.
- On speed high, 1, 2 and 3 indicators will be on.
- When fan off, no fan speed indicator will be on.
LED LIGHT STRIP
If the LED is damaged, it must be replaced only by the manufacturer, its service agent or
similarly qualifi ed persons in order to avoid a hazard.
- 15 -