EdilKamin NANCY Installation, Usage Et Maintenance page 37

POSSIBLE TROUBLESHOOTING
1)
Air ow may be insuf cient because the door is open, the door does not close properly (e.g. bad seal), there is an
air inta e or smo e extraction problem, or the combustion chamber is clogged.
Chec :
door closure;
combustion air inta e duct (clean, paying attention to the ow sensor components);
clean the ow sensor with dry air (li e that used for C eyboards);
stove location: it must not be installed against a wall;
combustion chamber position and cleanliness (clean regularly according to the type of pellet);
smo e duct (clean);
installation (if it does not comply with regulations or the smo e outlet has more than - bends);
If you suspect the sensor is malfunctioning, carry out cold tests. If the conditions are changed (for example by
opening the door) and the value does not change, there is a sensor problem.
he no depression alarm may also occur during ignition, since the ow sensor starts monitoring 9 seconds after
the ignition cycle begins.
Chec smo e extractor function (devolution sensor connection) and board (DEALER).
Chec smo e channel for dirt
erify the electrical system and earthing system.
Chec eletronic circuit board (DEALER).
interprets as the absence of ames)
urns off due to drop in smo e temperature
lac of pellets
too many pellets have suffocated the ame, chec pellet quality (DEALER)
the maximum thermostat has intervened (rare, this only intervenes in the event of excessive smo e
temperature) (DEALER)
temperature is not reached).
Distinguish either of the following cases:
Chec : - combustion chamber position and cleanliness;
arrival of combustion air in the combustion chamber;
if the heating element is wor ing (DEALER);
room temperature (if lower than
ry to light with a relighter (see page
Chec : (only by the Dealer)
if the thermocouple is wor ing (DEALER);
start-up temperature setting in the parameters (DEALER).
Repeat start up after having emptying the brazier.
Chec electricity connection and drops in voltage.
Chec connection of thermo coupling to board: chec function in cold test (DEALER).
(intervenes if the ow sensor detects insuf cient combustion ).
(this trips if the smo e extraction speed sensor detects a fault)
(this trips if the thermocouple detects a smo e temperature lower than the value set, which it
(intervenes if a ame fails to appear within a maximum of
C use a relighter) and damp.
(not a defect of the stove).
(intervenes if the thermo coupling has failed or is disconnected).
).
- 37
-
minutes, or if ignition