Publicité
Les langues disponibles
Les langues disponibles
DEVICES
he stove must NO be installed in the same room as
extractors, type B heating appliances and other appliances
that may affect its operation. See regulation NI
he stove is supplied with a power cable that is to be connected
to a
z soc et, preferably tted with a
magnetothermic switch. In the event that the power outlet is
not easily accessible, provide a device to cut off the power
supply (a switch) upstream of the stove (must be provided
by the customer). oltage variations exceeding
damage the stove.
he electrical system must comply with the law; particularly
verify the ef ciency of the earthing system.
An inadequate earthing system can cause anomalies for which
Edil amin cannot be held liable.
he power line must have a suitable cross-section for the sto-
ve's power.
FIRE PREVENTION SAFETY DISTANCES
he stove can be attached directly to bric and/or plasterboard
walls. In the case of combustible walls (wood, for
example), you must install adequate insulation in a non
combustible material. You are required to adequately insulate
the smo e exhaust pipe and the warm air channelling
pipe, as they reach high temperatures. All elements made
from combustible and/or heat-sensitive material located
ad acent to the stove must be arranged at a distance of no
less than
cm or otherwise be adequately insulated with
non combustible insulating material, and in any case materials
can not be placed at less than 8 cm in front of the
stove as they are directly exposed to the heat radiating
from the hearth.
AIR INTAKE
here must be an air inlet behind the stove with a minimum
diameter of 8 cm . his must be connected to the
outside in order to guarantee suf cient air supply to the
stove for combustion.
he air inta e must be connected to the dedicated nozzle on the
bac of the stove (see pg.
INSTALLATION
8 .
% can
).
SMOKE OUTLET
he smo e exhaust is expelled through the 8 cm-diameter
outlet located on the bac , right side or top. he smo e outlet
must be connected to outside by means of suitable steel pipes
and must be free from obstructions. he stove smo e dischar-
ge must be connected with outside by means of steel or blac
pipes EN 8
certi ed. he pipe line must be hermetically
sealed. he pipes must be sealed and insulated using materials
that are resistant to high temperatures(high temperature silicone
or mastic). he only horizontal section allowed may be up to
m long. It is possible to use up to two curves with a maxi-
mum angle of 9
(with respect to the vertical axis). A vertical
section of at least . m and an anti-wind terminal is necessary
(if the discharge outlet is not in a chimney ue) (reference NI
8 ). he vertical duct can be internal or external. If the
smo e channel is outside, it must be appropriately insulated.
If the smo e channel is tted inside a chimney ue, the latter
must be suitable for solid fuel. If it is wider than
diameter it must be improved by entering a pipe that has a
suitable cross-section and is made of suitable material (e.g. 8
mm diameter steel). All sections of the smo e duct must be
accessible for inspection. he chimney pots and smo e ducts
connected to the solid fuel appliances must be cleaned once a
year (verify whether a speci c legislation exists in your count-
ry). Failure to regularly inspect and clean the stove increases
the probability of a re occurring
in the chimney pot. In that case, proceed as follows: Do not
use water to extinguish the re; Empty the pellet hopper; Con-
tact specialist personnel before reigniting the stove.
TYPICAL EXAMPLES
insulated steel ue
minimum height of . m and in any case above the height of the
roof gutter
air inta e from inside room (minimum internal section: 8 cm )
steel ue, inside existing bric -built chimney.
CHIMNEY POT
he main characteristics are:
- an internal cross-section at the base, which is the same as that
of the chimney ue
- an outlet cross-section which is no smaller than twice that of
the chimney ue
- its position must be high enough to catch the wind and avoid
downdraft areas in turbulent wind, it must be high enough to
catch the wind and avoid downdraft areas in turbulent wind.
- 26
-
mm in
Publicité
