EdilKamin NANCY Installation, Usage Et Maintenance page 32

he rst time you use the product, or should the tan be completely emptied of pellets, to ll the coclea press both eys " "
and " " on the remote control at the same time, holding for a few seconds. As you release the eys, the display should show the
wording "LOAD". his should be carried out before ignition if the stove has stopped due to having run out of pellets, at the end of
operation to empty the combustion pot before turning.
It is quite normal for some pellets to remain, that the cochlea cannot suction.
ith the stove on stand-by, press and hold the ey
ignition procedure, showing the wording "S AR ". At the same time, a countdown in seconds begins (from
Ignition is not at a preset time, however: its duration is automatically shortened if the board reports that certain tests have
been passed. he ame appears after about minutes.
emperatures of below C will not allow the electrical resistance to heat suf ciently. In this case, or should the
resistance be temporarily out of action, Diavolina® type re-starters can be used.
Insert a piece of lit Diavolina into the combustion chamber, close the door and press
ith the stove wor ing, press the ey " " on the remote control once. he display will show the word " O ER ".
(specifying the power at which the insert is wor ing). ress the eys " " or " " to increase or decrease the insert's
wor ing power (from " O ER
ress ey "A" to switch to automatic operation, ad usting the temperature desired for the room (use the " " and " " eys
to set the temperature from
If a temperature below that of the room is set, the insert will stay on " O ER
ith the stove running, press and hold the ey
showing a countdown on the display from 9 to (for a total of
he turn-off phase involves:
Interruption of pellet supply
aximum ventilation.
Smo e expulsion motor.
OPERATIONS THAT CAN ONLY BE CARRIED OUT BY REMOTE CONTROL
ress and hold the ey " " for seconds to access the "Cloc " menu. his allows you to set the internal electronic board
cloc . By then pressing the ey " ", the following data appears in sequence and can be regulated:
day, month, year, hour, minutes, day of the wee .
he wording "SA E " will appear for con rmation with " ". his will allow you to chec that the operations performed are
correct, prior to completion (the wording "SA E" will then be shown on the display).
INSTRUCTIONS FOR USE
, on the remote control for seconds. his will start-up the
" to " O ER ").
C to C, and the stove will regulate wor ing power required to reach the temperature set.
rom the remote control for seconds. he turn-off procedure will begin,
the remote control.
".
minutes).
- 32
-
to ).