Beurer BM 28 Mode D'emploi page 28

• Insert the mains part into the connection provided for
this purpose on the right-hand side of the blood pres-
sure monitor.
• Then insert the mains plug of the mains part into the
mains socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it
from the blood pressure monitor. As soon as you unplug
the mains part, the blood pressure monitor loses the date
and time setting but the saved measured values are re-
tained.
Adjusting the settings
Make sure that the device's settings have been set correctly
so you can make full use of all its functions. Otherwise you
will not be able to save your measured values with the date
and time and access them later.
There are two different ways to access the settings menu:
• Before initial use and after each time you replace the
battery:
When inserting batteries into the device, you will be tak-
en to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off, press and hold the SET
button for approx. 5 seconds.
To set the date and time, proceed as follows:
• Select 12h or 24h mode using the function buttons -/+.
Press SET to confirm. The year display will start to flash.
Set the year with the function buttons -/+ and confirm
with SET.
• Set the month, day, hour and minute and confirm each
with the SET button.
• The blood pressure monitor switches itself off automat-
ically.
Alarm
Set alarm:
You can set 2 different alarm times to remind yourself to take
the measurement. To set the alarm, proceed as follows:
• Press and hold the function buttons - and + simultane-
ously for 5 seconds.
• Alarm 1 is shown in the display; "on" or "off" flashes
at the same time. With the function buttons -/+, choose
whether alarm 1
or deactivated ("off" flashes) and confirm with the SET
button.
• If alarm 1 is deactivated ("off") you automatically
switch to setting alarm 2
• If alarm 1 is activated, the hours flash on the display.
Select the desired hour using the function buttons -/+
and confirm with SET. The minutes flash on the display.
Select the desired minute using the function buttons -/+
and confirm with SET.
• Alarm 2 is shown in the display, "on" or "off" flashes
at the same time. To set, proceed as for alarm 1
blood pressure monitor switches itself off automatically.
28
should be activated ("on" flashes)
.
. The