Replacing The Light Bulb; Sliding Rack Kit Assembly - SCHOLTES BC 99D P 0 XA Mode D'emploi

GB
F
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.

Replacing the light bulb

Lamp
Holder
compartment
Lamp
Glass cover
! Do not touch the light bulb directly with your hands.
! Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly*

Left
Right guide
guide rail
rail
B
C
*
Only available on certain models.
32
F
3. Grip the door on the two outer sides and
close it approximately half way. Unlock the
door by pressing on the clamps F, then pull
the door towards you, lifting it out of its slot
(see diagram).
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap G 9.
3. Replace the glass cover (see
diagram).
To assemble the sliding racks:
1. Remove the two frames, lifting them
away from the spacers A (see figure).
A
2. Choose which shelf to use with the
sliding rack. Paying attention to the
direction in which the sliding rack is to
be extracted, position joint B and then
joint C on the frame.
D
! Do not place the sliding racks in position 5.
Automatic cleaning using the FAST CLEAN function
During the FAST CLEAN cycle, the internal temperature of the oven reaches
500°C. The pyrolytic cycle is activated, burning away food and grime
residues. Dirt is literally incinerated.
Keep children well away from the appliance during the automatic cleaning
cycle, as the surfaces may become extremely hot. Particles may ignite inside
the oven due to the combustion process. Particles may ignite inside the oven
as a result of the combustion process. This is not a cause for concern; it is a
normal process and is completely safe.
Before initiating the FAST CLEAN mode:
! We recommend the duration of the first automatic cleaning cycle is set to
120 minutes.
! The oven should be cold. If the oven is too hot, the pyrolytic cycle may not
start. Wait for the oven to cool down.
• remove larger food residues from inside the oven using a damp sponge.
Do not use detergent.
• remove all accessories.
• remove the DIVIDER.
• do not leave tea towels or pot holders on the oven handle.
! The cycle will only begin once the oven door has been closed.
! The desired Fast Clean mode will be confirmed and started automatically
if the CLOCK icon button is not pressed within 10 seconds from selecting
the cooking time.
! If the oven is too hot, the pyrolysis cycle may not begin or the word END
may appear on the display. Wait for the oven to cool down.
To start the FAST CLEAN cycle, turn the EXTRALARGE SPACE FUNCTION
knob to .
The SET TIME button may be used to select the desired cleaning level. There
are three default time settings, which cannot be modified:
1. Economy (ECO): turn the knob towards " ". Duration: 1 hour.
2. Normal (NOR): initial level. Duration: 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards " ". Duration: 2 hours.
4. Press the button to confirm.
The end of the FAST CLEAN cycle may be programmed in the same way as
a normal cooking cycle (see Programming the automatic cleaning end time).
3. Secure the two frames with the
guide rails using the holes provided
on the oven walls (see diagram). The
holes for the left frame are situated at
the top, while the holes for the right
frame are at the bottom.
4. Finally, fit the frames on the spacers