M.back Angle Performance; N.tension Adjustable Upholstery - Quickie 7R Mode D'emploi

Q UI C KIE 7R
M. BACK ANGLE PERFORMANCE
Adjusting the Angle of the Backrest
1. Release the backrest by pulling the adjustable tension pull cord (A) with a simple, short force.
2. While maintaining tension on the release cord, rotate the backrest to the desired angle, either forward
or rearward.
3. Lock the backrest in place by releasing the cord and allowing the pins (B) to engage in the nearest hole
(C) of the backrest bracket (D).
Folding and Unfolding the Backrest
1. Release the backrest by pulling the adjustable tension pull cord (A) with a simple, short force.
2. While maintaining tension on the release cord, rotate the backrest to unfold it. Remove the cushion and
push down hard to lock it in the folded position.
3. Lock the backrest in the folded position by removing your cushion. Release the pull-cord, and push
down hard allowing the pins (B) to engage in the folded position hole (E) of the backrest bracket (D).
Be sure the pins (B) are fully engaged through the backrest bracket (D) on both sides of the chair,.
Test the backrest to be sure it is locked before use.
N. TENSION ADJUSTABLE UPHOLSTERY
Installing standard Tension Adjustable Backrest Upholstery
®
1. Slide Velcro straps (F) over the backrest frame (G) section. Make sure to include at least
one strap below the towel bar (if using a rigid chair).
2. Tighten the straps appropriately to desired tension level. DO NOT over tighten straps as this
will cause undue strain upon the chair backrest frame (G).
3. If using fold down push handles, insert the single Velcro
front of the push handles ( I ).
If using integral push handles ( J ), slide straps from bottom of backrest upward.
4. Install backrest cover at desired level and fold over rear of Velcro
Quickie patch should be upright on the rear of the chair.
5. Finish installation by placing vanity flap (center panel) down onto Velcro
secure attachment (L).
Any changes made to the straps will affect the center of gravity. It is best to have the attendant sta-
tioned behind the wheelchair to prevent the wheelchair from tipping backwards while the user
becomes accustomed to the adjustment.
MK-100084 Rev. A
19 20
WARNING
21 22 23 24
®
strap (F) through the slots in the
®
WARNING
18
VIII. USE AND MAINTENANCE
strapping system (K). The
®
on the seat sling to
19
20
B
21
F
G
22
H
I
23
J
F
24