Yamaha RS90NL Supplément Au Manuel De D'atelier page 96

a
b
9. Install: (RS90N/RS90NR/RS90RS/RS90MS)
• Handlebar 1
• Handlebar holders 2
CAUTION:
First, tighten the bolts on the front side of the
handlebar holder, and then on the rear side.
1
NOTE:
2
• The handlebar holders should be installed with
the punch marks a facing forward.
• Align the match mark b on the handlebar with
the upper surface of the steering joint.
10. Install: (RS90GT)
• Handlebar
CAUTION:
• Be sure the projection on the handlebar is not
installed into the area a shown.
• Be sure the side of the holder with the small
gap b faces forward.
• First tighten the bolts on the front side of the
handlebar holder, and then tighten the bolts
on the rear side.
• Center the match mark c on the handlebar 1
between the lower handlebar holder 2.
11. Check:
• Ski toe-out
39
CHAS
STEERING
Handlebar holder bolt:
15 Nm (1.5 m · kg, 11 ft · lb)
Handlebar holder bolt:
15 Nm (1.5 m · kg, 11 ft · lb)
Refer to "STEERING SYSTEM" in CHAPTER
2.