Table des Matières
Publicité
C
3
È
C
1
C
2
Ì
È
DRIVE CHAIN HOUSING
INSTALLATION
1. During installation, pay attention to the follow-
ing.
È Properly install the rubber seal onto the drive chain
housing, making sure that there are no gaps.
É Make sure that the bearing seals face towards the
drive chain as shown.
C
C
C
1
2
3
Ë
Ë 0.2 ~ 0.7 mm (0.008 ~ 0.028 in)
Ì 0 ~ 1.0 mm (0 ~ 0.04 in)
For the jackshaft and drive chain housing installa-
tion, refer to "SECONDARY SHAFT".
É
2. Install:
• Lever rod 1
3. Adjust:
• Lever rod length a
Adjustment steps:
• Loosen the locknuts 2.
• Turn the lever rod 1 in or out until the specified
length is obtained.
• Tighten the locknuts.
52
POWR
TR
Be sure to install the spacers in their original
positions, otherwise the brake disc and jack-
shaft will stick.
: ESSO beacon 325 grease or Aeroshell grease
#7A
Lever rod length:
27 mm (1.06 in)
Publicité
Table des Matières
