Table des Matières
Publicité
C
3
É
C
1
C
2
DRIVE CHAIN HOUSING
INSTALLATION
Ë
For the jackshaft and drive chain housing installa-
tion, refer to "SECONDARY SHAFT".
È
È
47
1. During installation, pay attention to the follow-
ing.
È Make sure that the bearing seals face towards the
drive chain as shown.
É Properly install the rubber seal onto the drive chain
housing, making sure that there are no gaps.
Be sure to install the spacers in their original
C
C
C
1
2
3
positions, otherwise the brake disc and jack-
shaft will stick.
Ë 0.2 ~ 0.7 mm (0.008 ~ 0.028 in)
: ESSO beacon 325 grease or Aeroshell grease
#7A
2. Fill:
• Drive chain housing oil
Refer to "DRIVE CHAIN" in CHAPTER 2.
3. Adjust:
• Drive chain slack
Refer to "DRIVE CHAIN" in CHAPTER 2.
POWR
TR
Publicité
Table des Matières
