Improper Use Of Compressor; Safety Measures - Schneider Airsystems AirMaster AM 11-8 E1 Notice D'utilisation D'origine

4 IMPROPER USE OF COMPRESSOR

The manufacturer shall waive all responsibility in case of:
a Incorrect use by untrained or negligent personnel.
b Use in violation of current laws.
c Incorrect installation.
d Installation without suitable reservoir.
e Installation in dust-filled environments (i.e. cement, silica etc.....).
f Incorrect electrical connection.
g Serious lack of proper maintenance.
h Use of non-original spares for the model.
i Total or partial failure to observe the instructions.
j Damage due to natural or exceptional events.
k Tampering with the safety valve.
l Exceeding maximum pressure rating through tampering.
m Operation of compressor without panels and guards.

5 SAFETY MEASURES

Read carefully to avoid potential risks.
DANGER
Handling................................................. Base designed for use with forklift and transpallet forklift.
Electrical Connection ............................. Built-in full load AC23-filled circuit-breaker.
Electrical Board...................................... Bolted on, with door interlock switch.
Emergency............................................. Built- in yellow/red warning light.
Short Circuit ........................................... Built-in line fuses.
Motor Overload ...................................... Magneto-thermal cut-out.
Electrostatic Discharge .......................... De-oiling filter with electrical continuity.
Compressor Overheat ........................... 110 °C thermostat with cut-out.
Insufficient Lubrication ........................... 110 °C thermostat for 'adiabatic' compression.
Starting Under Load............................... 10 sec. delay from energizing
Overpressure ......................................... Approved safety valve.
Back-Pressure ....................................... Non-return valve
Residual Pressure ................................. Descharge tap and internal air gauge.
Phase Reversal
(wrong direction of rotation)
Temperature
Max. Environment > 40° C .................... 110 °C thermostat.
Min Environment < 2° C...................... See starting recommendations.
Pressure Parts ....................................... Built to 2009/105/EG standards.
Flexible Hoses ....................................... High pressure hose used (4-6 times working pressure).
Hot Surfaces .......................................... Parts reaching 70 °C + marked with warnings
MEASURES
Indicator arrow or R.S.F. electronic relay
2-6