Publicité
3 609 929 A31.book Seite 1 Mittwoch, 3. August 2005 3:35 15
Tool Specifications
Straight grinder
Article number
Rated power input
[W]
Output power
[W]
No-load speed
[rpm]
Grinder spindle
thread
Tool holder
[mm]
Grinding wheel-Ø,
max.
[mm]
Weight according
to EPTA-Procedure
01/2003
[kg]
Safety class
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
The values given are valid for nominal voltages [U] of
230/240 V. However, these values can vary for lower
voltages and models made for specific countries.
Tool Elements
The numbering of the tool elements refers to the
representation of the tool on the graphics page.
While reading the operating instructions, unfold
the graphics page of the tool and leave it open.
1 Clamping nut
2 Protection guard
3 Grinder spindle
4 Mounting flange
5 On/Off switch
6 Lock-on button for On/Off switch/anti-start
safety lock
7
quick clamping nut
8 Two-hole wrench for clamping nut
9 Retaining pin
Not all of the illustrated or described accessories are
included as standard delivery.
Intended Use
The machine is designed for grinding and deburr-
ing metal using corundum grinding tools. The
machine is also suitable for working with knot-
ted-wire cup brushes.
4 • 3 609 929 A31 • 05.08
Noise/Vibration Information
Measured values determined according to
GGS 6 S
EN 50 144.
PROFESSIONAL
0 601 214 1..
The A-weighted noise levels of the tool are typi-
cally: Sound pressure level: 86 dB (A); sound
1 150
power level: 99 dB (A).
670
Wear hearing protection!
6 800
The weighted acceleration is typically 7.0 m/s
M 14
Ø 20
125
3.9
/ II
Additionally, the general safety instructions either
in the enclosed booklet or those added in the
center of these operating instructions must be ob-
served.
SAVE THESE INSTRUCTIONS.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. Both hands guide a
power tool more securely.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Do not work materials containing asbes-
tos. Asbestos is considered carcinogenic.
Take protective measures when dust can
develop during working that is harmful to
one's health, combustible or explosive. Ex-
ample: Some dusts are regarded as carcino-
genic. Wear a dust mask and work with dust /
chip extraction when connectable.
Keep your workplace clean. Material mix-
tures are particularly dangerous. Dust of light
metal can be inflammable or explode.
Do not use a power tool with a damaged
power cord. Do not touch the damaged
cord and pull the power plug when the cord
is damaged while working. Damaged cords
increase the risk of an electric shock.
Connect power tools that are used in the
open via a ground fault circuit interrupter.
English - 1
For Your Safety
Read all instructions. Failure to fol-
low all instructions listed below may
result in electric shock, fire and/or
serious injury.
Wear safety goggles.
2
.
Publicité
