Programming The Rm-Vlz620 Consecutive Procedures - Sony RM-VLZ620 Mode D'emploi

4
Enter the desired channel
number.
Notes
 You can press up to four buttons among
the number buttons,  (dot), and
ENTER.
If you press any other button, the SET
indicator flashes once and turns off,
and the setting is canceled.
 If you press four buttons, the setting
mode ends and the channel will be
programmed.
5
Press SET to complete the
programming.
The SET indicator flashes three
times, and the indicators turn off.
3 flashes
You can now select the channel
by pressing just the number 9
button.
To cancel the process
Press and hold SET for more than 3
seconds. The indicators turn off.
To clear the program
1
Press and hold SET for more than
3 seconds.
The SET indicator lights up.
While keeping SET held down,
press the desired Device Select
button.
2
Enter  -  - 1.
The SET indicator flashes three
times.
3
Press and hold the programmed
number button you want to reset
for more than 3 seconds.
When the program is cleared, the
SET indicator flashes three times
and turns off.
28
US
Programming the RM-
VLZ620 Consecutive
Procedures
You can program a consecutive
procedure and perform them by
pressing just one button.
You can program up to 16
consecutive steps to each of the
SYSTEM CONTROL buttons (1 – )
or the Device Select buttons.
To perform the programmed
procedure:
– Press the programmed SYSTEM
CONTROL button.
– Press and hold the programmed
Device Select button for more
than 2 seconds*.
* If you release the button within 2 seconds,
the Device Select button will function to
select the device mode.
Notes
 If another consecutive procedure has
already been set on the button, it will be
overwritten with the new one.
 If the button has already learned a
function, the setting procedure will be
canceled. Clear the learned function (page
26).
Example: To program a
consecutive procedure to
watch a DVD to the SYSTEM
CONTROL 2 button:
Power on the TV.

Power on the DVD player.

Power on the amplifier.

Set the input selector of the
amplifier to DVD input.

Set the input mode of the TV to
VIDEO 1.

Start DVD playback.