Location For The Optional Prolink; Remote Monitoring System; Electrical Safety - Jacuzzi J-400 Manuel D'installation Et Utilisation Et Entretien

I
The suction fittings are sized to match the water flow created by
the pump. If they are replaced, make sure that the flow rate is the
same. Never operate the spa if the suction fittings are broken
or missing. Never replace a suction fitting with one rated less
than the flow rate marked on the original suction fitting.
I Keep hair, hair clips, and other objects, such as neck-
laces, far away from the suction nozzles, filters, and the
skimmer cover. Make certain that children do not play or
swim near this equipment.
I Do not sit on the suction nozzles, filters or the skimmer
cover. Make certain that children do not play or swim near
this equipment.
I When the spa is in use, do not use any electrical appliance,
unless such appliances are built-in by the manufacturer.
I The water in a spa should never exceed 40 °C. Lower water
temperatures are recommended for young children, preg-
nant women and when spa use exceeds 10 minutes.
I Persons with heart conditions, diabetes, high or low blood
pressure or other health problems must not use the spa with-
out first consulting their doctor.
I The use of alcohol, narcotics or medicines may cause
drowsiness, and affect pulse rate, blood pressure and circu-
lation. Avoid using these substances before getting into the
spa.
I Do not use a spa immediately following strenuous exer-
cise.
I Be very careful when getting in an out of the spa. All of the
surfaces are slippery when wet.
I The spa is not intended for use in public places; always
check for any restrictions and/or regulations concerning the
installation and use of the apparatus in the area chosen.
Location for the Optional ProLink™ Remote Mo-
nitoring System
IMPORTANT! Choose an installation site with the front control
panel side pointing towards your home's Wi-Fi router.
CAUTION: You must make sure that the spa control panel side
has a clear unobstructed line-of-site of the home Wi-Fi router.
This action ensures maximum signal strength between the spa
and your home's Wi-Fi router.
Verify your home router's Wi-Fi strength at the proposed spa lo-
cation. Front control panel side of spa must point towards your
home's Wi-Fi router in your home as illustrated.
Stand near the proposed front control panel side of the spa with
your cell phone, then login to the internet using your home Wi-Fi
router signal (not 3G or 4G) and verify results as follows:
If the home Wi-Fi router signal is strong (3-4 bars) and Internet
access is stable, the proposed installation site is a good choice.
If the home router's Wi-Fi signal is weak and Internet access is
slow or produces an error, the proposed installation site is not a
good choice.
It may be necessary to choose another spa installation site.
Relocate your home Wi-Fi router closer to the spa.
Install a "repeater" device in the room closest to the spa to
boost the home's router Wi-Fi signal at the proposed spa in-
stallation site.

Electrical safety

®
The MaxiJacuzzi are safe products, manufactured in compli-
ance with standards EN 60335-1, EN 60335-2-60, EN 12764
and tested during production to ensure user safety.
I Installation must be performed by qualified personnel who
ensure compliance with current national regulations and who
are also authorized to issue a certificate of compliance with
proper installation procedures.
It is the responsibility of the installer to select materials
based on their intended use, to carry out work prop-
erly, to check the condition of the system that the unit
will be connected to and that it ensures safety of use
also concerning maintenance work and the possibility
to examine the system.
I The MaxiJacuzzi
® are class "I" appliances and therefore they
must be permanently connected, without any intermediate
connections, to the eectrical system and to the protection
system (earth system)
34
Home WiFi
Router
Home WI-FI
Router