Oxford HOTGRIPS EVO ADVENTURE EL420 Instructions De Montage Et D'utilisation page 8

instructions v.9 control - GB
temperature is measured.
To change the desired temperature press
35 degrees (2.5 degrees steps).
To turn the power OFF from any heat setting, either hold the
until no power lights are lit.
Switch Features
New – The switch now has 5 temperature setting – 45 – 42.5 – 40 – 37.5 – 35 Degrees
New – The HotGrips EVO are now more intelligent than ever, constantly feeding back the
thermistor reading from each grip to the control module to regulate the power output to
each grip, keeping them a constant set temperature.
New- If connected to the ignition, the switch will remember the last heat setting you
used and return to that setting when the vehicle is restarted.
New – Reduced heat up time to set temperatures – the controller will supply full power
from start to reach the set temperature.
New – The new wire heating element pattern provides an upgraded heat distribution
around the user's hand.
New – Waterproof cable exit – increasing the life of the product.
• Battery Saving Mode (BSM)
- If the battery voltage is lower 13.5V then it recognizes if either the battery voltage
falls too low, or it's high enough but suspiciously quiet (ie. The engine has stopped).
This feature is turned on as standard at the factory.
- When in this state, the BSM LED flashes, the power LED still lights as normal, and
the button still works – but the grips don't get powered.
- As soon as the battery voltage recovers and/or there's a bit of noise on the power
supply, the 'Battery saving' LED goes out and the grips work as normal
- The controller goes into BSM after 5 seconds of the voltage being less than 11.5V,
or after 2 minutes of not detecting any noise on the 12V power lead. Once in this
mode, it will wait a further 5 minutes before switching off completely.
- If the rider does not want or like this feature, the BSM can be disabled by switching
the controller on and then pressing and holding both buttons together for 5
seconds. During this time, the BSM LED will indicate whether the BSM feature is
currently enabled (LED on) or disabled (LED off). After 5 seconds the state of the
LED will change, and the user can let go of the buttons
- The controller remembers this state permanently, or until the user switches it back
by repeating the above procedure.
K: TECHNICAL DATA:
• This switch is extremely efficient and in standby will only draw 71 micro-amps
(0.071mA). Therefore long term connection will not flatten a battery.
• This switch can offer power up to 10amps although the HotGrips themselves will only
draw 3.6Amps on average.
• This switch has been lab-tested to ensure EMC compliance and more importantly has
been subjected to the most severe automotive spike and pulse laboratory testing to
ensure that none of the electrical circuits on the motorcycle could damage or interfere
8
or to reduce the temperature from 45 –
button for 2 seconds