Oxford HOTGRIPS EVO ADVENTURE EL420 Instructions De Montage Et D'utilisation page 4

instructions v.9 control - GB
from the inside of the HotGrips.
6. When sliding the grips onto the handlebars it is possible to twist them into place until
they reach the correct finished position.
7. Ensure that the throttle (right) grip operates freely and returns to the closed position
without abnormal friction. If the grip binds on return then it indicates that the fit
between the throttle tube and grip is too tight.
G: POSITIONING ON HANDLEBARS:
1. Position the grips so that the wires do not foul against the brake/clutch levers. The
throttle grip should rotate freely without obstruction and without stretching or
pinching the wires. Ensure that the grips cable entry point is below the level of the
clutch and brake lever (Shown below).
H: WIRING HARNESS INSTALLATION:
1. Before removing the grips for the final fitting procedure, it is important to connect
the electrical wiring harness to the battery and the grips. With the motorcycle engine
running the grips can be switched on to make sure that the grips operate as expected.
2. Find a suitable location to mount the switch and then take the wiring back to the
battery.
3. Install the switch in a suitable position ensuring the wires from the grips reach without
strain.
4. The switch may be mounted on a flat panel using the self-adhesive mounting foam
pad. It may also be mounted on the metal bracket supplied (if the bracket is suitable
for the vehicle). Please fit the foam pad between the brackets and switch to reduce
vibrations. The bracket may also be bent to a different angle as required.
On many motorcycles it is possible to fit the bracket to the clutch clamp as shown below
using the longer bolts provided.
4