Oxford HOTGRIPS EVO ADVENTURE EL420 Instructions De Montage Et D'utilisation page 2

instructions v.9 control - GB
Oxford HotGrips™ EVO: Fitting and User Guide for part codes: EL420 Adventure, EL421
Touring & EL422 Sports HotGrips™ with V.9 heat controllers.
This product comes with a 1 year limited warranty.
IMPORTANT: KEEP FOR FUTURE REFERENCE
A: WARNINGS
1. IMPORTANT: Read this guide carefully before fitting or using!
2. If you have any doubt about fitting your Oxford HotGrips™ EVO, immediately consult
your local authorized Oxford stockist for advice or alternatively visit our website www.
oxfordproducts.com and check for updates on the Frequently Asked Questions and
Fitment Videos.
3. Before using the motorcycle/vehicle each time, please ensure that the fitted HotGrips
are firmly glued to the handlebar. Failure to do so could result in an accident or
personal injury.
4. The superglue will bond skin and eyes in seconds. Keep out of reach of children.
5. Ensure that the throttle operates freely. Ensure that normal operation of the
motorcycle is not affected. The Hotgrip cables must not foul or restrict the operation
of the brake or clutch levers.
6. HotGrips are designed for use with gloved hands. Check the temperature for suitability
before you set off. If the temperature becomes too hot when on the move, pull over
safely and turn the temperature down.
7. Do not leave the motorcycle unattended when the HotGrips are turned on.
8. Replace the HotGrips when the pattern of the outer rubber wears away in any one
area or the tread pattern disappears.
9. Regularly check the integrity of the attachment and materials of your HotGrips. Do
not use if in doubt and consult your local authorised Oxford Products stockist.
10. Oxford Products will accept no liability for the consequences of grips, which have not
been securely fitted. Liability is limited to the replacement parts of the HotGrips in
case of faulty materials or manufacture.
B: PARTS LIST
Before fitting, check that the following parts are included in the kit:
- 1 x Left HotGrip (22mmØ I/D)
- 1 x Right HotGrip (25.6mmØ I/D)
- 1 x Intelligent Heat Controller and adhesive pad
- 1 x Universal bracket for switch – OF91
- 1 x Wiring loom (1.35mtr long)
- Cable ties and grip superglue
C: TOOLS NEEDED:
- A coarse and fine file for smoothing the throttle slider tube
- Glasspaper for cleaning the handlebars
- Cable snippers or pliers
- Standard motorcycle tools to remove the seat, fairing panels and battery connections
D: GRIP LENGTHS AND TRIMMING TO FIT
Your Oxford HotGrips EVO are designed as a replacement for the handlebar grips
already fitted to the motorcycle. HotGrips will fit onto most motorcycles that use 22mm
or 7/8" Ø handlebars. The grip has an open end to allow for the bar end weight to be
2