Update The Software With Cf Card; Profile Create Notice - iSolution IL-2420 Manuel D'utilisation

9. Update the software with CF card

Format the program of the controller , then download the last software and
copy to CF ： \SUP2420\APP2420.SUP ， inset the CF card to the seat, press
FIXTURE and OVERRIDE and number button 15 then Power on afresh
until the information show on the LCD display, the controller will test if the
CF card stick well and then update the new software, it will cost about 20 seconds, please
don't move the CF card or cut the power in order to avoid update frustrated and damage
the CF card.
Save the program first, or updating the software may lead the memory program useless.
Please refer to "Write CF card" and "Read CF card" to operate.
NOTICE ： ： ： ： T he format of the CF card should be FAD12 or FAD16, but not FAD32 and
NTFS, be sure there is no long-name files under the root directory (the amount of the
name below 8), the character must be start with letters, and compose with letters or
number or underline.

10. PROFILE Create notice

10.1 PROFILE.CIF(as the profile cyclostyle)
The finished file should use a short name below 8 characters, All use capital letters
and suffix with CIF transitorily. (IL-2420 controller nonsupport long file name) or the
controller can't read up the profile information.
10.2 IM-1200S.CIF is the profile of ACME IM-1200S
10.3 Enactment special code, so the controller should distill some channel
characteristic to manage.
; ARRT CODE
; D = DIMMER
; P = PAN
; PF = PAN FINE
; T = TILT
; TF = TILT FINE
; G = ALL GOBO CORRELATION CHANNLES
DIMMER
PAN
PAN FINE in 16 channel mode
TILT
TILT FINE in 1 6 channel mode
transfer all gobo correlation channel
to preset gobo
108-
; C = ALL COLOR CORRELATION CHANNLES
; N = ETCAETERAS CHANNELS
10.4 The channel display message should be no more than 4 capital letters or
underline or number, and must be bracket with double quotation marks. Don't
replace by blank if shorter 4 character.
You'd better input in English mode, ensure all the input characters are DBC but not SBC
case
① "DIM" ;right
② "DIM " ;wrong for the blank
③ "dim" "DIm" ;wrong for the lowercase
④ " D IM " ;wrong for the SBC double quotation marks
10.5 Don't change the group which contain";********"
10.6 Store the profile that you want to input to the controller under the root directory
of CF card.
EXP: If CF card is disk F, then the file input route should be "F:\DIR2402\IM-1200S"
10.7 The format of CF card should be FAT16 but not FAT32.
IL-2420 PROFILE ;********
VER1.0 ;********
; ADD ACME AND OTHER LIGHT LIBBER SELECT
DEFAULT ACME; ACME AND OTHER
; FACTORY / MODEL MODEL = MAX 16 CHARACTER
NAME "AMCE" "IM-1200SZ-24"
; LIGHT CHANNEL NUMBER MAX 24
CHANNEL 24
DMX ;********
transfer all color correlation channel
to preset gobo
else channels should be signed N
109-