Delete A Chase; Program A Preset - iSolution IL-2420 Manuel D'utilisation

3. Press the number button 1-20 to select the chase number to delete from.
4. Use Jog wheel #2 to select the scene location you want
to delete.
5. Press AUTO/DEL all LEDs blink for 3 times to indicate that you have
successfully deleted the scene.
6. Repeat steps 4-5to delete more scenes from the chase.
7. Press the button CHASE to store the operation and exit from the present
programming state.
8. Press the button PROGRAM for 3 seconds to exit Program mode, the
LED goes out indicating this operation.

4.13 Delete a CHASE

1. Enter Program mode.
2. Press the button CHASE, use jog wheel #1 to select the page number,
choose the programming chase.
3. Press the button AUTO/DEL.
4. Press the number button 1-20 to select the chase to be deleted, all LEDs
blink for 3 times to indicate that you have successfully delete the chase.
5. Repeat the steps 2-4 to delete more chases.
76-
6. Press the button PROGRAM for 3 seconds to exit Program mode, the
LED goes out indicating this operation.

4.14 Program a Preset

1. Enter Program mode.
2. Press the button FIXTURE
3. Press the button 1-20 to select the concerned fixture of preset
programming.
4. Move the FADERS1-24 to change COLOR/GOBO channel values (The
codes of the channel feature of ARRT CODE are "C" and "G" in the fixtures
bank)output for the convenience to check other channels but the channel
output will not be stored in the preset.
5. Press the button MANUAL/REC at this moment all LEDs on buttons
CUE 、 O VERRIDE 、 C ENTER 、 F IXTURE GROUP 、 P RESET 、 C HASE 、
BANK 、 B LACKOUT blink at the same time.
6. Press the button PRESET
7. Use Jog wheel #1 to select the preset group number 1-20.
8. Press one of the number button 1-10
one of the number button 11-20 to store a GOBO preset, all LEDs blink for 3
times to indicate that you have successfully store a Preset.
9. Repeat Steps 2-8 to program more Presets.
to store a COLOR preset or Pres
77-