Center Editing; Program An Override - iSolution IL-2420 Manuel D'utilisation

8. Repeat steps 2-7to program more Center positions.
9. Press PROGRAM button for 3 seconds to exit Program mode, the LED
goes out indicating this operation.

4.19 Center Editing

1. Enter Program mode.
2. Press CENTER button.
3. Press the number button1-20 to select the edited Center position
number.
4. Press FIXTURE button.
5. Press the number button 1-20 to select the concerned fixtures to be
programmed.
6. Move FADERS1-24 and use Jog wheel #3 ， # 4 to change the center
position of PAN 、 T ILT where you desired. (The codes of the channel feature
of ARRT CODE are "P" 、 " PF" 、 " T" 、 " TF" in the fixtures bank ） f or the
convenience to check other channels, there would be some output of
the channels, but the channel output will not be stored in the center.
7. Press MANUAL/REC button, at this moment, all LEDs on CUE 、
OVERRIDE 、 C ENTER 、 F IXTURE GROUP 、 P RESET 、 C HASE 、
BANK 、 B LACKOUT blink at the same time.
82-
8. Press CENTER button.
9. Press the number button 1-20 to select the location to store the Center,
all LEDs blink for 3 times to indicate that you have successfully edited a
Center position.
10. Press PROGRAM button for 3 seconds to exit Program mode, the LED
goes out indicating this operation.
NOTE: If you press different buttons in step 3 and 9, the center position you set in step 3 will
cover the one in step 9.

4.20 Program an Override

1. Enter Program mode.
2. Press FIXTURE button.
3. Press the number button 1-20 to select the concerned fixtures to be
programmed.
4. Use FADERS1-24 and 4 Jog wheels to adjust the selected fixture to your
desired effect.
5. Press MANUAL/REC Button ， a t this moment, all LEDs on CUE 、
OVERRIDE 、 C ENTER 、 F IXTURE GROUP 、 P RESET 、 C HASE 、 B ANK 、
BLACKOUT blink at the same time.
6. Press OVERRIDE button.
83-