Blackout Mode Select; Midi Channel Select; Chase Run By Inside/Outside Time; Auto Remote Address - iSolution IL-2420 Manuel D'utilisation

5.7 Blackout mode select

1. Enter Menu Mode.
2. Turn Jog wheel #1 up to when the 07. Blackout mode select is shown on
the monitor press ENTER/MAIN MENU button to enter.
3. Turn Jog wheel #2 to chose Stand by or Pan/tilt center or Blackout
scene.
4. Press ENTER/MAIN MENU Button to enter, all the LEDs will blink for 3
times, then back to the last menu.

5.8 Midi channel select

1. Enter Menu Mode.
2. Use Jog wheel #1 up to when the 08.Midi channel select is shown on the
monitor Press ENTER/MAINMENU Button to enter.
3. Use Jog wheel #2 to chose the channel of MIDI （ 0 -16 ） , it's enlarge mode
when the value of the MIDI channel is 0, so MIDI can receive the
information of 1-16 channels.
4. Press ENTER/MAIN MENU Button to enter, all the LEDs will blink for 3
times, then back to the last menu.

5.9 Chase run by inside/outside time

1. Enter Menu Mode.
2. Turn jog wheel #1 up to when the 09.Chase run by inside/outside time is
shown on the monitor, Press ENTER/MAINMENU Button to enter
94-
3. Use Jog wheel #2 to chose Chase run by inside time or Chase run by
outside time
4. Press ENTER/MAIN MENU Button to enter, all the LEDs will blink for 3
times, then back to the last menu.

5.10 Auto remote address

This function is used only for the fixtures which can be addressed long-distance, ensure the
unit match this requirements before operation, or it will be of no effect .
1. Enter Menu Mode.
2. Turn Jog wheel #1 up to when the 10. Auto remote address is shown on
the monitor Press ENTER/MAIN MENU Button to enter
3. Use Jog wheel #2 to select Yes (enter) or NO (quit to the main menu) .
4. Press ENTER/MAIN MENU Button to set the address of the fixture, wait
for 3 seconds, so the fixture can receive the signal of the controller and
move all the motors to their "home" position.
5. After 3 seconds, use jog wheel #2 to select the fixtures of the first group,
and jog wheel #4 to select the fixtures of the second group. When you
turn the jog wheel #2 or #4, the cursor will switch between the first and
second group. The fixtures of this two group will be selected in turn, and the
unit will act differently when it be selected.
6. Press number Button 1-20 ， all the LEDs will blink for 3 times, the address
of the corresponding fixture will show on the LCD display, it means the
fixture's amount of the channel is as same as the corresponding number
95-