Patch A Fixture; Reverse Channel Setup; Fade Mode Setup - iSolution IL-2420 Manuel D'utilisation

5.4 Patch a Fixture

1. Enter Menu Mode.
2. Turn Jog wheel #1 up to when the 04. Patch a Fixture is shown on the
monitor Press ENTER/MAIN MENU Button to enter.
3. Press number Button 1-20 to chose the fixture which needs to patch.
4. Turn Jog wheel #3 to chose the profile of other manufacturers and Jog
wheel #4 to chose ACME's.
5. Press ENTER/MAIN MENU Button to enter, all the LEDs strobe for 3
times.
6. Repeat 3-5 to patch all the fixtures.
7. Back to the last menu please press ESC/CLEAR button.

5.5 Reverse channel setup

1. Enter Menu Mode.
2. Turn Jog wheel #1 up to when the 05. Reverse channel setup is shown
on the monitor press ENTER/MAIN MENU Button to enter.
3. Press number Button 1-20 to chose the fixture which needs to reverse.
92-
4. Turn Jog wheel #2 to change the position of the cursor, and Jog wheel #4
used to reverse the channel.
5. Turn Jog wheel #3 to chose the channel, Jog wheel #4 to reverse.
6. Press ENTER/MAIN MENU Button to enter, all the LEDs will blink for 3
times.
7. Repeat 3-6 to reverse other channels.
8. Back to the last menu please press ESC/CLEAR button.

5.6 Fade mode setup

1. Enter Menu Mode.
2. Turn Jog wheel #1 up to when the 06. Fade mode setup is shown on the
monitor, press ENTER/MAIN MENU button to enter.
3. Turn Jog wheel #2 to select only pan/tilt or all channel.
4. Press ENTER/MAIN MENU Button to enter, all the LEDs will blink for 3
times, then back to the last menu.
93-