Fixture Group Editing; Program A Center - iSolution IL-2420 Manuel D'utilisation

8. Press PROGRAM button 3 seconds to exit Program mode, the LED goes
out indicating this operation.

4.17 FIXTURE GROUP Editing

1. Enter Program mode.
2. Press FIXTURE GROUP button.
3. Press the number button 1-20 to select the fixture group number to be
edited.
4. Press FIXTURE button.
5. Press the number button 1-20 to select one or more fixtures to make the
fixture group.
6. Press MANUAL/REC button ， a t this moment, all LEDs on CUE 、
OVERRIDE 、 C ENTER 、 F IXTURE GROUP 、 P RESET 、 C HASE 、 B ANK 、
BLACKOUT blink at the same time.
7. Press FIXTURE GROUP button.
8. Press the number button 1-20 to select the fixture group number you
selected in step 2, all LEDs blink for 3 times
9. Press PROGRAM button for 3 seconds to exit Program mode, the LED
80-
goes out indicating this operation.
NOTE: If you press different buttons in step 3 and 7, the fixture group you selected in step 4
will cover the one in step 7.

4.18 Program a Center

1. Enter Program mode.
2. Press FIXTURE button.
3. Press the number button 1-20 to select the concerned fixtures to be
programmed.
4. Move FADERS1-24 and use Jog wheel #3 ， # 4 to change the center
position of PAN 、 T ILT where you desired. (The codes of the channel feature
of ARRT CODE are "P" 、 " PF" 、 " T" 、 " TF" in the fixtures bank ） f or the
convenience to check other channels, there would be some output of the
channels, but the channel output will not be stored in the center.
5. Press MANUAL/REC button, at this moment, all LEDs on CUE 、
OVERRIDE 、 C ENTER 、 F IXTURE GROUP 、 P RESET 、 C HASE 、 B ANK 、
BLACKOUT blink at the same time.
6. Press CENTER button.
7. Press the number button 1-20 to select the location to store the Center all
LEDs blink for 3 times to indicate that you have successfully stored a Center
position.
81-